powerpc/BSC9132QDS: Enable creation of dynamic partition for NAND and NOR
* fdt_fixup_mtdparts is called from ft_board_setup
* run "mtdparts default" to create NAND, NOR partition on uboot
* Use mtdparts to create partitions dynamically rather
than using static partitions in device tree
Signed-off-by: Ashish Kumar <Ashish.Kumar@freescale.com>
Reviewed-by: York Sun <yorksun@freescale.com>
diff --git a/board/freescale/bsc9132qds/bsc9132qds.c b/board/freescale/bsc9132qds/bsc9132qds.c
index 10580bc..c88838b 100644
--- a/board/freescale/bsc9132qds/bsc9132qds.c
+++ b/board/freescale/bsc9132qds/bsc9132qds.c
@@ -21,6 +21,9 @@
#include <hwconfig.h>
#include <i2c.h>
#include <fsl_ddr_sdram.h>
+#include <jffs2/load_kernel.h>
+#include <mtd_node.h>
+#include <flash.h>
#ifdef CONFIG_PCI
#include <pci.h>
@@ -354,6 +357,12 @@
}
#if defined(CONFIG_OF_BOARD_SETUP)
+#ifdef CONFIG_FDT_FIXUP_PARTITIONS
+struct node_info nodes[] = {
+ { "cfi-flash", MTD_DEV_TYPE_NOR, },
+ { "fsl,ifc-nand", MTD_DEV_TYPE_NAND, },
+};
+#endif
void ft_board_setup(void *blob, bd_t *bd)
{
phys_addr_t base;
@@ -369,6 +378,9 @@
#endif
fdt_fixup_memory(blob, (u64)base, (u64)size);
+#ifdef CONFIG_FDT_FIXUP_PARTITIONS
+ fdt_fixup_mtdparts(blob, nodes, ARRAY_SIZE(nodes));
+#endif
ccsr_gur_t *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR);
u32 porbmsr = in_be32(&gur->porbmsr);