warp7: Remove UART initialization code
With DM_SERIAL selected, it is no longer needed board code to
initialize the UART.
Describe the nodes that require dm-pre-reloc, which allows
the DM model to configure the UART pinctrl early.
Remove the now unneeded board UART initialization.
Signed-off-by: Fabio Estevam <festevam@denx.de>
diff --git a/configs/warp7_bl33_defconfig b/configs/warp7_bl33_defconfig
index 949790c..3f91211 100644
--- a/configs/warp7_bl33_defconfig
+++ b/configs/warp7_bl33_defconfig
@@ -17,6 +17,7 @@
CONFIG_FIT_VERBOSE=y
CONFIG_USE_BOOTCOMMAND=y
CONFIG_BOOTCOMMAND="mmc dev ${mmcdev};mmc dev ${mmcdev}; if mmc rescan; then run do_bootscript_hab;if run loadbootscript; then run bootscript; else if run loadimage; then run mmcboot; fi; fi; fi"
+# CONFIG_BOARD_EARLY_INIT_F is not set
CONFIG_HUSH_PARSER=y
CONFIG_CMD_BOOTZ=y
CONFIG_CMD_MEMTEST=y
diff --git a/configs/warp7_defconfig b/configs/warp7_defconfig
index ab7299c..b349d54 100644
--- a/configs/warp7_defconfig
+++ b/configs/warp7_defconfig
@@ -21,6 +21,7 @@
CONFIG_FIT_VERBOSE=y
CONFIG_USE_BOOTCOMMAND=y
CONFIG_BOOTCOMMAND="mmc dev ${mmcdev};mmc dev ${mmcdev}; if mmc rescan; then run do_bootscript_hab;if run loadbootscript; then run bootscript; else if run loadimage; then run mmcboot; fi; fi; fi"
+# CONFIG_BOARD_EARLY_INIT_F is not set
CONFIG_HUSH_PARSER=y
# CONFIG_CMD_BOOTD is not set
CONFIG_CMD_BOOTZ=y