am335x: configs: Use ISW_ENTRY_ADDR to set SPL_TEXT_BASE
The SPL load address changes based on boot type in HS devices,
ISW_ENTRY_ADDR is used to set this address for AM43xx based SoCs
for similar reasons. Add this same logic for AM33xx devices.
Also make the default value for ISW_ENTRY_ADDR correct for GP
devices based on SoC, HS devices already pick the correct
value in their defconfig.
Signed-off-by: Andrew F. Davis <afd@ti.com>
diff --git a/arch/arm/mach-omap2/am33xx/Kconfig b/arch/arm/mach-omap2/am33xx/Kconfig
index 8fd32c2..56c4406 100644
--- a/arch/arm/mach-omap2/am33xx/Kconfig
+++ b/arch/arm/mach-omap2/am33xx/Kconfig
@@ -119,7 +119,8 @@
point address depending on the device type
(secure/non-secure), boot media (xip/non-xip) and
image headers.
- default 0x402F4000
+ default 0x402F4000 if AM43XX
+ default 0x402F0400 if AM33XX
config PUB_ROM_DATA_SIZE
hex "Size in bytes of the L3 SRAM reserved by ROM to store data"
diff --git a/include/configs/ti_am335x_common.h b/include/configs/ti_am335x_common.h
index d841b3f..809d015 100644
--- a/include/configs/ti_am335x_common.h
+++ b/include/configs/ti_am335x_common.h
@@ -56,7 +56,7 @@
* supports X-MODEM loading via UART, and we leverage this and then use
* Y-MODEM to load u-boot.img, when booted over UART.
*/
-#define CONFIG_SPL_TEXT_BASE 0x402F0400
+#define CONFIG_SPL_TEXT_BASE CONFIG_ISW_ENTRY_ADDR
#define CONFIG_SYS_SPL_ARGS_ADDR (CONFIG_SYS_SDRAM_BASE + \
(128 << 20))