sunxi: axp221: Explicitly turn off unused voltages
Explicitly turn off unused voltages, rather then leaving them as is. Likewise
explictly enabled the dcdc convertors, rather then assuming they are already
enabled at boot.
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Acked-by: Ian Campbell <ijc@hellion.org.uk>
diff --git a/drivers/power/Kconfig b/drivers/power/Kconfig
index e132759..ef0c093 100644
--- a/drivers/power/Kconfig
+++ b/drivers/power/Kconfig
@@ -19,9 +19,9 @@
config AXP221_DLDO1_VOLT
int "axp221 dldo1 voltage"
depends on AXP221_POWER
- default -1
+ default 0
---help---
- Set the voltage (mV) to program the axp221 dldo1 at, set to -1 to
+ Set the voltage (mV) to program the axp221 dldo1 at, set to 0 to
disable dldo1. On sun6i (A31) boards with ethernet this is often used
to power the ethernet phy. On sun8i (A23) boards this is often used to
power the wifi.
@@ -29,17 +29,17 @@
config AXP221_DLDO4_VOLT
int "axp221 dldo4 voltage"
depends on AXP221_POWER
- default -1
+ default 0
---help---
- Set the voltage (mV) to program the axp221 dldo4 at, set to -1 to
+ Set the voltage (mV) to program the axp221 dldo4 at, set to 0 to
disable dldo4.
config AXP221_ALDO1_VOLT
int "axp221 aldo1 voltage"
depends on AXP221_POWER
- default -1
+ default 0
---help---
- Set the voltage (mV) to program the axp221 aldo1 at, set to -1 to
+ Set the voltage (mV) to program the axp221 aldo1 at, set to 0 to
disable aldo1. On sun6i (A31) boards which have a wifi module this is
often used to power the wifi module.
@@ -49,7 +49,7 @@
default 1800 if MACH_SUN6I
default 2500 if MACH_SUN8I
---help---
- Set the voltage (mV) to program the axp221 aldo2 at, set to -1 to
+ Set the voltage (mV) to program the axp221 aldo2 at, set to 0 to
disable aldo2. On sun6i (A31) boards this is typically connected to
VCC-PM, which powers the port M gpios, and should be set to 1.8V.
On sun8i (A23) this is typically connected to VDD-DLL and must be
@@ -60,6 +60,6 @@
depends on AXP221_POWER
default 3000
---help---
- Set the voltage (mV) to program the axp221 aldo3 at, set to -1 to
+ Set the voltage (mV) to program the axp221 aldo3 at, set to 0 to
disable aldo3. This is typically connected to VCC-PLL and AVCC and
must be set to 3V.