arm: s5p4418: dm_serial: switch to DM_SERIAL
Switch the S5P4418-SOC and therefore the s5p4418_nanopi2 board to
DM_SERIAL.
Signed-off-by: Stefan Bosch <stefan_b@posteo.net>
diff --git a/arch/arm/mach-nexell/Kconfig b/arch/arm/mach-nexell/Kconfig
index 86a2398..16324e1 100644
--- a/arch/arm/mach-nexell/Kconfig
+++ b/arch/arm/mach-nexell/Kconfig
@@ -6,8 +6,8 @@
select OF_CONTROL
select OF_SEPARATE
select NX_GPIO
- select PL011_SERIAL
- select PL011_SERIAL_FLUSH_ON_INIT
+ select DM_SERIAL
+ select PL01X_SERIAL
help
Enable support for Nexell S5P4418 SoC.
diff --git a/drivers/serial/Kconfig b/drivers/serial/Kconfig
index 14b0feb..bb50832 100644
--- a/drivers/serial/Kconfig
+++ b/drivers/serial/Kconfig
@@ -827,6 +827,15 @@
help
Select this to enable Samsung S5P UART support.
+config S5P4418_PL011_SERIAL
+ bool "Extended PL011 driver for S5P4418"
+ depends on DM_SERIAL && PL01X_SERIAL && ARCH_NEXELL
+ default y
+ help
+ Select this to enable support of the PL011 UARTs in the S5P4418 SOC.
+ With this driver the UART-clocks are set to the appropriate rate
+ (if not 'skip-init').
+
config SANDBOX_SERIAL
bool "Sandbox UART support"
depends on SANDBOX
diff --git a/drivers/serial/Makefile b/drivers/serial/Makefile
index 37d3f82..01fef3f 100644
--- a/drivers/serial/Makefile
+++ b/drivers/serial/Makefile
@@ -59,6 +59,7 @@
obj-$(CONFIG_HTIF_CONSOLE) += serial_htif.o
obj-$(CONFIG_SIFIVE_SERIAL) += serial_sifive.o
obj-$(CONFIG_XEN_SERIAL) += serial_xen.o
+obj-$(CONFIG_S5P4418_PL011_SERIAL) += serial_s5p4418_pl011.o
ifndef CONFIG_SPL_BUILD
obj-$(CONFIG_USB_TTY) += usbtty.o