arm: dts: k3-j721e: Add DT nodes for USB
J721e has two instances of Cadence USB3 controller. Add DT nodes for the
same. USB0 is configured to device mode and USB1 is configured to host
mode. For now only high speed mode is supported.
Signed-off-by: Vignesh Raghavendra <vigneshr@ti.com>
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
diff --git a/arch/arm/dts/k3-j721e-common-proc-board.dts b/arch/arm/dts/k3-j721e-common-proc-board.dts
index c978cab..137da7e 100644
--- a/arch/arm/dts/k3-j721e-common-proc-board.dts
+++ b/arch/arm/dts/k3-j721e-common-proc-board.dts
@@ -77,3 +77,40 @@
voltage-ranges = <1800 1800 3300 3300>;
ti,driver-strength-ohm = <50>;
};
+
+&main_pmx0 {
+ main_usbss0_pins_default: main_usbss0_pins_default {
+ pinctrl-single,pins = <
+ J721E_IOPAD(0x290, PIN_OUTPUT, 0) /* (U6) USB0_DRVVBUS */
+ J721E_IOPAD(0x210, PIN_INPUT, 7) /* (W3) MCAN1_RX.GPIO1_3 */
+ >;
+ };
+
+ main_usbss1_pins_default: main_usbss1_pins_default {
+ pinctrl-single,pins = <
+ J721E_IOPAD(0x214, PIN_OUTPUT, 4) /* (V4) MCAN1_TX.USB1_DRVVBUS */
+ >;
+ };
+};
+
+&usbss0 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&main_usbss0_pins_default>;
+ ti,vbus-divider;
+};
+
+&usb0 {
+ dr_mode = "otg";
+ maximum-speed = "super-speed";
+};
+
+&usbss1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&main_usbss1_pins_default>;
+ ti,usb2-only;
+};
+
+&usb1 {
+ dr_mode = "host";
+ maximum-speed = "high-speed";
+};