arm64: xilinx: Put ethernet phys to mdio node
All zynqmp boards have been already described via mdio node that's why also
convert the rest of the boards. With using mdio node there is an option to
add reset property for the whole mdio bus which is reflected by
's/phy-reset-gpios/reset-gpios/g' for some boards.
Signed-off-by: Michal Simek <michal.simek@amd.com>
Link: https://lore.kernel.org/r/ff165281a70a38e2b76fee91e6255ce95ce8021b.1695378830.git.michal.simek@amd.com
diff --git a/arch/arm/dts/zynqmp-dlc21-revA.dts b/arch/arm/dts/zynqmp-dlc21-revA.dts
index 016081e..f737004 100644
--- a/arch/arm/dts/zynqmp-dlc21-revA.dts
+++ b/arch/arm/dts/zynqmp-dlc21-revA.dts
@@ -88,9 +88,13 @@
phy-handle = <&phy0>;
phy-mode = "sgmii"; /* DTG generates this properly 1512 */
is-internal-pcspma;
- /* phy-reset-gpios = <&gpio 142 GPIO_ACTIVE_LOW>; */
- phy0: ethernet-phy@0 {
- reg = <0>;
+ mdio: mdio {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ /* reset-gpios = <&gpio 142 GPIO_ACTIVE_LOW>; */
+ phy0: ethernet-phy@0 {
+ reg = <0>;
+ };
};
};