avr32: Enable SPI flash support on ATNGW100
The ATNGW100 has 8MB DataFlash on board. Give users access to it through
the new SPI flash framework.
Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
diff --git a/board/atmel/atngw100/atngw100.c b/board/atmel/atngw100/atngw100.c
index 375f0e7..f2c3e79 100644
--- a/board/atmel/atngw100/atngw100.c
+++ b/board/atmel/atngw100/atngw100.c
@@ -60,6 +60,9 @@
#if defined(CONFIG_MMC)
gpio_enable_mmci();
#endif
+#if defined(CONFIG_ATMEL_SPI)
+ gpio_enable_spi0(1 << 0);
+#endif
return 0;
}
@@ -89,3 +92,25 @@
gd->bd->bi_phy_id[0] = 0x01;
gd->bd->bi_phy_id[1] = 0x03;
}
+
+/* SPI chip select control */
+#ifdef CONFIG_ATMEL_SPI
+#include <spi.h>
+
+#define ATNGW100_DATAFLASH_CS_PIN GPIO_PIN_PA3
+
+int spi_cs_is_valid(unsigned int bus, unsigned int cs)
+{
+ return bus == 0 && cs == 0;
+}
+
+void spi_cs_activate(struct spi_slave *slave)
+{
+ gpio_set_value(ATNGW100_DATAFLASH_CS_PIN, 0);
+}
+
+void spi_cs_deactivate(struct spi_slave *slave)
+{
+ gpio_set_value(ATNGW100_DATAFLASH_CS_PIN, 1);
+}
+#endif /* CONFIG_ATMEL_SPI */