make pm9263 buildable for v2011.06 release
Signed-off-by: Asen Chavdarov Dimov <dimov@ronetix.at>
diff --git a/board/ronetix/pm9263/led.c b/board/ronetix/pm9263/led.c
index 4e585a4..d6eb69f 100644
--- a/board/ronetix/pm9263/led.c
+++ b/board/ronetix/pm9263/led.c
@@ -24,17 +24,16 @@
*/
#include <common.h>
-#include <asm/arch/at91sam9263.h>
#include <asm/arch/at91_pmc.h>
-#include <asm/arch/at91_pio.h>
-#include <asm/arch/io.h>
+#include <asm/arch/gpio.h>
+#include <asm/io.h>
void coloured_LED_init(void)
{
- at91_pmc_t *pmc = (at91_pmc_t *) AT91_PMC_BASE;
+ struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
/* Enable clock */
- writel(1 << AT91SAM9263_ID_PIOB, &pmc->pcer);
+ writel(1 << ATMEL_ID_PIOB, &pmc->pcer);
at91_set_pio_output(CONFIG_RED_LED, 1);
at91_set_pio_output(CONFIG_GREEN_LED, 1);
diff --git a/board/ronetix/pm9263/pm9263.c b/board/ronetix/pm9263/pm9263.c
index 8071600..cfc9847 100644
--- a/board/ronetix/pm9263/pm9263.c
+++ b/board/ronetix/pm9263/pm9263.c
@@ -26,16 +26,14 @@
#include <common.h>
#include <asm/sizes.h>
-#include <asm/arch/at91sam9263.h>
+#include <asm/io.h>
#include <asm/arch/at91sam9_smc.h>
#include <asm/arch/at91_common.h>
#include <asm/arch/at91_pmc.h>
#include <asm/arch/at91_rstc.h>
#include <asm/arch/at91_matrix.h>
-#include <asm/arch/at91_pio.h>
#include <asm/arch/clk.h>
-#include <asm/arch/io.h>
-#include <asm/arch/hardware.h>
+#include <asm/arch/gpio.h>
#include <lcd.h>
#include <atmel_lcdc.h>
#include <dataflash.h>
@@ -55,8 +53,8 @@
static void pm9263_nand_hw_init(void)
{
unsigned long csa;
- at91_smc_t *smc = (at91_smc_t *) AT91_SMC0_BASE;
- at91_matrix_t *matrix = (at91_matrix_t *) AT91_MATRIX_BASE;
+ struct at91_smc *smc = (struct at91_smc *)ATMEL_BASE_SMC0;
+ struct at91_matrix *matrix = (struct at91_matrix *)ATMEL_BASE_MATRIX;
/* Enable CS3 */
csa = readl(&matrix->csa[0]) | AT91_MATRIX_CSA_EBI_CS3A;
@@ -95,7 +93,7 @@
#ifdef CONFIG_MACB
static void pm9263_macb_hw_init(void)
{
- at91_pmc_t *pmc = (at91_pmc_t *) AT91_PMC_BASE;
+ struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
/*
* PB27 enables the 50MHz oscillator for Ethernet PHY
@@ -106,7 +104,7 @@
at91_set_pio_value(AT91_PIO_PORTB, 27, 1); /* 1- enable, 0 - disable */
/* Enable clock */
- writel(1 << AT91SAM9263_ID_EMAC, &pmc->pcer);
+ writel(1 << ATMEL_ID_EMAC, &pmc->pcer);
/*
* Disable pull-up on:
@@ -145,7 +143,7 @@
vl_vsync_len: 1,
vl_upper_margin:1,
vl_lower_margin:0,
- mmio: AT91SAM9263_LCDC_BASE,
+ mmio: ATMEL_BASE_LCDC,
};
void lcd_enable(void)
@@ -168,8 +166,8 @@
{
volatile uint16_t x;
unsigned long csa;
- at91_smc_t *smc = (at91_smc_t *) AT91_SMC1_BASE;
- at91_matrix_t *matrix = (at91_matrix_t *) AT91_MATRIX_BASE;
+ struct at91_smc *smc = (struct at91_smc *)ATMEL_BASE_SMC1;
+ struct at91_matrix *matrix = (struct at91_matrix *)ATMEL_BASE_MATRIX;
/* Enable CS3 3.3v, no pull-ups */
csa = readl(&matrix->csa[1]) | AT91_MATRIX_CSA_DBPUC |
@@ -249,7 +247,7 @@
static void pm9263_lcd_hw_init(void)
{
- at91_pmc_t *pmc = (at91_pmc_t *) AT91_PMC_BASE;
+ struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
at91_set_a_periph(AT91_PIO_PORTC, 0, 0); /* LCDVSYNC */
at91_set_a_periph(AT91_PIO_PORTC, 1, 0); /* LCDHSYNC */
@@ -275,7 +273,7 @@
at91_set_a_periph(AT91_PIO_PORTC, 26, 0); /* LCDD22 */
at91_set_a_periph(AT91_PIO_PORTC, 27, 0); /* LCDD23 */
- writel(1 << AT91SAM9263_ID_LCDC, &pmc->pcer);
+ writel(1 << ATMEL_ID_LCDC, &pmc->pcer);
/* Power Control */
at91_set_pio_output(AT91_PIO_PORTA, 22, 1);
@@ -285,9 +283,9 @@
/* initialize te PSRAM */
int stat = pm9263_lcd_hw_psram_init();
- gd->fb_base = (stat == 0) ? PHYS_PSRAM : AT91SAM9263_SRAM0_BASE;
+ gd->fb_base = (stat == 0) ? PHYS_PSRAM : ATMEL_BASE_SRAM0;
#else
- gd->fb_base = AT91SAM9263_SRAM0_BASE;
+ gd->fb_base = ATMEL_BASE_SRAM0;
#endif
}
@@ -341,14 +339,14 @@
int board_init(void)
{
- at91_pmc_t *pmc = (at91_pmc_t *) AT91_PMC_BASE;
+ struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
/* Enable Ctrlc */
console_init_f();
- writel((1 << AT91SAM9263_ID_PIOA) |
- (1 << AT91SAM9263_ID_PIOCDE) |
- (1 << AT91SAM9263_ID_PIOB),
+ writel((1 << ATMEL_ID_PIOA) |
+ (1 << ATMEL_ID_PIOCDE) |
+ (1 << ATMEL_ID_PIOB),
&pmc->pcer);
/* arch number of AT91SAM9263EK-Board */
@@ -357,7 +355,7 @@
/* adress of boot parameters */
gd->bd->bi_boot_params = PHYS_SDRAM + 0x100;
- at91_serial_hw_init();
+ at91_seriald_hw_init();
#ifdef CONFIG_CMD_NAND
pm9263_nand_hw_init();
#endif
@@ -400,7 +398,7 @@
{
int rc = 0;
#ifdef CONFIG_MACB
- rc = macb_eth_initialize(0, (void *)AT91_EMAC_BASE, 0x01);
+ rc = macb_eth_initialize(0, (void *)ATMEL_BASE_EMAC, 0x01);
#endif
return rc;
}
@@ -417,7 +415,7 @@
ss = "(PSRAM)";
break;
- case AT91SAM9263_SRAM0_BASE:
+ case ATMEL_BASE_SRAM0:
ss = "(Internal SRAM)";
break;