include/configs: Use new CONFIG_CMD_* in various t* and u* named board config files.
Signed-off-by: Jon Loeliger <jdl@freescale.com>
diff --git a/include/configs/uc101.h b/include/configs/uc101.h
index ff061ee..64461f6 100644
--- a/include/configs/uc101.h
+++ b/include/configs/uc101.h
@@ -38,11 +38,6 @@
#define BOOTFLAG_COLD 0x01 /* Normal Power-On: Boot from FLASH */
#define BOOTFLAG_WARM 0x02 /* Software reboot */
-#define CFG_CACHELINE_SIZE 32 /* For MPC5xxx CPUs */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
-# define CFG_CACHELINE_SHIFT 5 /* log base 2 of the above value */
-#endif
-
#define CONFIG_BOARD_EARLY_INIT_R
/*
@@ -55,25 +50,25 @@
/* Partitions */
#define CONFIG_DOS_PARTITION
-/*
- * Supported commands
- */
-#define CONFIG_COMMANDS (CONFIG_CMD_DFL | \
- CFG_CMD_DATE | \
- CFG_CMD_DISPLAY | \
- CFG_CMD_DHCP | \
- CFG_CMD_PING | \
- CFG_CMD_EEPROM | \
- CFG_CMD_I2C | \
- CFG_CMD_DTT | \
- CFG_CMD_IDE | \
- CFG_CMD_FAT | \
- CFG_CMD_NFS | \
- CFG_CMD_MII | \
- CFG_CMD_SNTP )
-/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
-#include <cmd_confdefs.h>
+/*
+ * Command line configuration.
+ */
+#include <config_cmd_default.h>
+
+#define CONFIG_CMD_DATE
+#define CONFIG_CMD_DISPLAY
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_PING
+#define CONFIG_CMD_EEPROM
+#define CONFIG_CMD_I2C
+#define CONFIG_CMD_DTT
+#define CONFIG_CMD_IDE
+#define CONFIG_CMD_FAT
+#define CONFIG_CMD_NFS
+#define CONFIG_CMD_MII
+#define CONFIG_CMD_SNTP
+
#define CONFIG_TIMESTAMP 1 /* Print image info with timestamp */
@@ -245,7 +240,7 @@
*/
#define CFG_LONGHELP /* undef to save memory */
#define CFG_PROMPT "=> " /* Monitor Command Prompt */
-#if (CONFIG_COMMANDS & CFG_CMD_KGDB)
+#if defined(CONFIG_CMD_KGDB)
#define CFG_CBSIZE 1024 /* Console I/O Buffer Size */
#else
#define CFG_CBSIZE 256 /* Console I/O Buffer Size */
@@ -264,6 +259,11 @@
#define CFG_HZ 1000 /* decrementer freq: 1 ms ticks */
+#define CFG_CACHELINE_SIZE 32 /* For MPC5xxx CPUs */
+#if defined(CONFIG_CMD_KGDB)
+# define CFG_CACHELINE_SHIFT 5 /* log base 2 of the above value */
+#endif
+
/*
* Enable loopw commando. This has only affect, if CFG_CMD_MEM is defined,
* which is normally part of the default commands (CFV_CMD_DFL)