blob: 429fe1b4ff3f6c8886a4f257f88d9e30903c389c [file] [log] [blame]
/*
* (C) Copyright 2008
* Graeme Russ, graeme.russ@gmail.com.
*
* See file CREDITS for list of people who contributed to this
* project.
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License as
* published by the Free Software Foundation; either version 2 of
* the License, or (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program; if not, write to the Free Software
* Foundation, Inc., 59 Temple Place, Suite 330, Boston,
* MA 02111-1307 USA
*/
#include <common.h>
#include <asm/io.h>
#include <asm/arch/sc520.h>
#include <net.h>
#include <netdev.h>
#ifdef CONFIG_HW_WATCHDOG
#include <watchdog.h>
#endif
#include "hardware.h"
DECLARE_GLOBAL_DATA_PTR;
unsigned long monitor_flash_len = CONFIG_SYS_MONITOR_LEN;
static void enet_timer_isr(void);
static void enet_toggle_run_led(void);
static void enet_setup_pars(void);
/*
* Miscellaneous platform dependent initializations
*/
int board_early_init_f(void)
{
u16 pio_out_cfg = 0x0000;
/* Configure General Purpose Bus timing */
writeb(CONFIG_SYS_SC520_GPCSRT, &sc520_mmcr->gpcsrt);
writeb(CONFIG_SYS_SC520_GPCSPW, &sc520_mmcr->gpcspw);
writeb(CONFIG_SYS_SC520_GPCSOFF, &sc520_mmcr->gpcsoff);
writeb(CONFIG_SYS_SC520_GPRDW, &sc520_mmcr->gprdw);
writeb(CONFIG_SYS_SC520_GPRDOFF, &sc520_mmcr->gprdoff);
writeb(CONFIG_SYS_SC520_GPWRW, &sc520_mmcr->gpwrw);
writeb(CONFIG_SYS_SC520_GPWROFF, &sc520_mmcr->gpwroff);
/* Configure Programmable Input/Output Pins */
writew(CONFIG_SYS_SC520_PIODIR15_0, &sc520_mmcr->piodir15_0);
writew(CONFIG_SYS_SC520_PIODIR31_16, &sc520_mmcr->piodir31_16);
writew(CONFIG_SYS_SC520_PIOPFS31_16, &sc520_mmcr->piopfs31_16);
writew(CONFIG_SYS_SC520_PIOPFS15_0, &sc520_mmcr->piopfs15_0);
writeb(CONFIG_SYS_SC520_CSPFS, &sc520_mmcr->cspfs);
writeb(CONFIG_SYS_SC520_CLKSEL, &sc520_mmcr->clksel);
/*
* Turn off top board
* Set StrataFlash chips to 16-bit width
* Set StrataFlash chips to normal (non reset/power down) mode
*/
pio_out_cfg |= CONFIG_SYS_ENET_TOP_BRD_PWR;
pio_out_cfg |= CONFIG_SYS_ENET_SF_WIDTH;
pio_out_cfg |= CONFIG_SYS_ENET_SF1_MODE;
pio_out_cfg |= CONFIG_SYS_ENET_SF2_MODE;
writew(pio_out_cfg, &sc520_mmcr->pioset15_0);
/* Turn off auxiliary power output */
writew(CONFIG_SYS_ENET_AUX_PWR, &sc520_mmcr->pioclr15_0);
/* Clear FPGA program mode */
writew(CONFIG_SYS_ENET_FPGA_PROG, &sc520_mmcr->pioset31_16);
enet_setup_pars();
/* Disable Watchdog */
writew(0x3333, &sc520_mmcr->wdtmrctl);
writew(0xcccc, &sc520_mmcr->wdtmrctl);
writew(0x0000, &sc520_mmcr->wdtmrctl);
/* Chip Select Configuration */
writew(CONFIG_SYS_SC520_BOOTCS_CTRL, &sc520_mmcr->bootcsctl);
writew(CONFIG_SYS_SC520_ROMCS1_CTRL, &sc520_mmcr->romcs1ctl);
writew(CONFIG_SYS_SC520_ROMCS2_CTRL, &sc520_mmcr->romcs2ctl);
writeb(CONFIG_SYS_SC520_ADDDECCTL, &sc520_mmcr->adddecctl);
writeb(CONFIG_SYS_SC520_UART1CTL, &sc520_mmcr->uart1ctl);
writeb(CONFIG_SYS_SC520_UART2CTL, &sc520_mmcr->uart2ctl);
writeb(CONFIG_SYS_SC520_SYSARBCTL, &sc520_mmcr->sysarbctl);
writew(CONFIG_SYS_SC520_SYSARBMENB, &sc520_mmcr->sysarbmenb);
/* enable posted-writes */
writeb(CONFIG_SYS_SC520_HBCTL, &sc520_mmcr->hbctl);
return 0;
}
static void enet_setup_pars(void)
{
/*
* PARs 11 and 12 are 2MB SRAM @ 0x19000000
*
* These are setup now because older version of U-Boot have them
* mapped to a different PAR which gets clobbered which prevents
* using SRAM for warm-booting a new image
*/
writel(CONFIG_SYS_SC520_SRAM1_PAR, &sc520_mmcr->par[11]);
writel(CONFIG_SYS_SC520_SRAM2_PAR, &sc520_mmcr->par[12]);
/* PARs 0 and 1 are Compact Flash slots (4kB each) */
writel(CONFIG_SYS_SC520_CF1_PAR, &sc520_mmcr->par[0]);
writel(CONFIG_SYS_SC520_CF2_PAR, &sc520_mmcr->par[1]);
/* PAR 2 is used for Cache-As-RAM */
/*
* PARs 5 through 8 are additional NS16550 UARTS
* 8 bytes each @ 0x013f8, 0x012f8, 0x011f8 and 0x010f8
*/
writel(CONFIG_SYS_SC520_UARTA_PAR, &sc520_mmcr->par[5]);
writel(CONFIG_SYS_SC520_UARTB_PAR, &sc520_mmcr->par[6]);
writel(CONFIG_SYS_SC520_UARTC_PAR, &sc520_mmcr->par[7]);
writel(CONFIG_SYS_SC520_UARTD_PAR, &sc520_mmcr->par[8]);
/* PARs 9 and 10 are 32MB StrataFlash @ 0x10000000 */
writel(CONFIG_SYS_SC520_SF1_PAR, &sc520_mmcr->par[9]);
writel(CONFIG_SYS_SC520_SF2_PAR, &sc520_mmcr->par[10]);
/* PAR 13 is 4kB DPRAM @ 0x18100000 (implemented in FPGA) */
writel(CONFIG_SYS_SC520_DPRAM_PAR, &sc520_mmcr->par[13]);
/*
* PAR 14 is Low Level I/O (LEDs, Hex Switches etc)
* Already configured in board_init16 (eNET_start16.S)
*
* PAR 15 is Boot ROM
* Already configured in board_init16 (eNET_start16.S)
*/
}
int board_early_init_r(void)
{
/* CPU Speed to 100MHz */
gd->cpu_clk = 100000000;
/* Crystal is 33.000MHz */
gd->bus_clk = 33000000;
return 0;
}
void show_boot_progress(int val)
{
uchar led_mask;
led_mask = 0x00;
if (val < 0)
led_mask |= LED_ERR_BITMASK;
led_mask |= (uchar)(val & 0x001f);
outb(led_mask, LED_LATCH_ADDRESS);
}
int last_stage_init(void)
{
int minor;
int major;
major = minor = 0;
outb(0x00, LED_LATCH_ADDRESS);
register_timer_isr(enet_timer_isr);
printf("Serck Controls eNET\n");
return 0;
}
ulong board_flash_get_legacy(ulong base, int banknum, flash_info_t *info)
{
if (banknum == 0) { /* non-CFI boot flash */
info->portwidth = FLASH_CFI_8BIT;
info->chipwidth = FLASH_CFI_BY8;
info->interface = FLASH_CFI_X8;
return 1;
} else {
return 0;
}
}
int board_eth_init(bd_t *bis)
{
return pci_eth_init(bis);
}
void setup_pcat_compatibility()
{
/* disable global interrupt mode */
writeb(0x40, &sc520_mmcr->picicr);
/* set all irqs to edge */
writeb(0x00, &sc520_mmcr->pic_mode[0]);
writeb(0x00, &sc520_mmcr->pic_mode[1]);
writeb(0x00, &sc520_mmcr->pic_mode[2]);
/*
* active low polarity on PIC interrupt pins,
* active high polarity on all other irq pins
*/
writew(0x0000, &sc520_mmcr->intpinpol);
/*
* PIT 0 -> IRQ0
* RTC -> IRQ8
* FP error -> IRQ13
* UART1 -> IRQ4
* UART2 -> IRQ3
*/
writeb(SC520_IRQ0, &sc520_mmcr->pit_int_map[0]);
writeb(SC520_IRQ8, &sc520_mmcr->rtcmap);
writeb(SC520_IRQ13, &sc520_mmcr->ferrmap);
writeb(SC520_IRQ4, &sc520_mmcr->uart_int_map[0]);
writeb(SC520_IRQ3, &sc520_mmcr->uart_int_map[1]);
/* Disable all other interrupt sources */
writeb(SC520_IRQ_DISABLED, &sc520_mmcr->gp_tmr_int_map[0]);
writeb(SC520_IRQ_DISABLED, &sc520_mmcr->gp_tmr_int_map[1]);
writeb(SC520_IRQ_DISABLED, &sc520_mmcr->gp_tmr_int_map[2]);
writeb(SC520_IRQ_DISABLED, &sc520_mmcr->pit_int_map[1]);
writeb(SC520_IRQ_DISABLED, &sc520_mmcr->pit_int_map[2]);
writeb(SC520_IRQ_DISABLED, &sc520_mmcr->ssimap);
writeb(SC520_IRQ_DISABLED, &sc520_mmcr->wdtmap);
writeb(SC520_IRQ_DISABLED, &sc520_mmcr->wpvmap);
writeb(SC520_IRQ_DISABLED, &sc520_mmcr->icemap);
}
void enet_timer_isr(void)
{
static long enet_ticks;
enet_ticks++;
/* Toggle Watchdog every 100ms */
if ((enet_ticks % 100) == 0)
hw_watchdog_reset();
/* Toggle Run LED every 500ms */
if ((enet_ticks % 500) == 0)
enet_toggle_run_led();
}
void hw_watchdog_reset(void)
{
/* Watchdog Reset must be atomic */
long flag = disable_interrupts();
if (sc520_mmcr->piodata15_0 & WATCHDOG_PIO_BIT)
sc520_mmcr->pioclr15_0 = WATCHDOG_PIO_BIT;
else
sc520_mmcr->pioset15_0 = WATCHDOG_PIO_BIT;
if (flag)
enable_interrupts();
}
void enet_toggle_run_led(void)
{
unsigned char leds_state = inb(LED_LATCH_ADDRESS);
if (leds_state & LED_RUN_BITMASK)
outb(leds_state & ~LED_RUN_BITMASK, LED_LATCH_ADDRESS);
else
outb(leds_state | LED_RUN_BITMASK, LED_LATCH_ADDRESS);
}