rename CFG_ macros to CONFIG_SYS
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
diff --git a/board/amcc/makalu/cmd_pll.c b/board/amcc/makalu/cmd_pll.c
index 0d2f27f..0f571fe 100644
--- a/board/amcc/makalu/cmd_pll.c
+++ b/board/amcc/makalu/cmd_pll.c
@@ -48,7 +48,7 @@
do { \
int __i; \
for (__i = 0; __i < 2; __i++) \
- eeprom_write (CFG_I2C_EEPROM_ADDR, \
+ eeprom_write (CONFIG_SYS_I2C_EEPROM_ADDR, \
EEPROM_CONF_OFFSET + __i*BUF_STEP, \
pll_select[freq], \
BUF_STEP + __i*BUF_STEP); \
@@ -151,7 +151,7 @@
uchar buffer[EEPROM_SDSTP_PARAM];
memset(buffer, 0, sizeof(buffer));
- eeprom_read(CFG_I2C_EEPROM_ADDR, off,
+ eeprom_read(CONFIG_SYS_I2C_EEPROM_ADDR, off,
buffer, EEPROM_SDSTP_PARAM);
printf("Debug: SDSTP[0-3] at offset \"0x%02x\" lists as follows: \n", off);
@@ -168,9 +168,9 @@
/*
* Write twice, 8 bytes per write
*/
- eeprom_write (CFG_I2C_EEPROM_ADDR, EEPROM_TEST_OFFSET,
+ eeprom_write (CONFIG_SYS_I2C_EEPROM_ADDR, EEPROM_TEST_OFFSET,
testbuf, 8);
- eeprom_write (CFG_I2C_EEPROM_ADDR, EEPROM_TEST_OFFSET+8,
+ eeprom_write (CONFIG_SYS_I2C_EEPROM_ADDR, EEPROM_TEST_OFFSET+8,
testbuf, 16);
printf("done\n");
@@ -236,7 +236,7 @@
}
U_BOOT_CMD(
- pllalter, CFG_MAXARGS, 1, do_pll_alter,
+ pllalter, CONFIG_SYS_MAXARGS, 1, do_pll_alter,
"pllalter- change pll frequence \n",
"pllalter <selection> - change pll frequence \n\n\
** New freq take effect after reset. ** \n\
diff --git a/board/amcc/makalu/makalu.c b/board/amcc/makalu/makalu.c
index fc79907..9fc0ec6 100644
--- a/board/amcc/makalu/makalu.c
+++ b/board/amcc/makalu/makalu.c
@@ -37,7 +37,7 @@
DECLARE_GLOBAL_DATA_PTR;
-extern flash_info_t flash_info[CFG_MAX_FLASH_BANKS]; /* info for FLASH chips */
+extern flash_info_t flash_info[CONFIG_SYS_MAX_FLASH_BANKS]; /* info for FLASH chips */
/*
* Board early initialization function
@@ -194,9 +194,9 @@
mtsdr(SDR0_SRST, 0);
/* Reset PCIe slots */
- gpio_write_bit(CFG_GPIO_PCIE_RST, 0);
+ gpio_write_bit(CONFIG_SYS_GPIO_PCIE_RST, 0);
udelay(100);
- gpio_write_bit(CFG_GPIO_PCIE_RST, 1);
+ gpio_write_bit(CONFIG_SYS_GPIO_PCIE_RST, 1);
/*
* Configure PFC (Pin Function Control) registers
@@ -213,7 +213,7 @@
#ifdef CONFIG_ENV_IS_IN_FLASH
/* Monitor protection ON by default */
flash_protect(FLAG_PROTECT_SET,
- -CFG_MONITOR_LEN,
+ -CONFIG_SYS_MONITOR_LEN,
0xffffffff,
&flash_info[0]);
#endif
@@ -286,9 +286,9 @@
/* setup mem resource */
pci_set_region(hose->regions + 0,
- CFG_PCIE_MEMBASE + i * CFG_PCIE_MEMSIZE,
- CFG_PCIE_MEMBASE + i * CFG_PCIE_MEMSIZE,
- CFG_PCIE_MEMSIZE,
+ CONFIG_SYS_PCIE_MEMBASE + i * CONFIG_SYS_PCIE_MEMSIZE,
+ CONFIG_SYS_PCIE_MEMBASE + i * CONFIG_SYS_PCIE_MEMSIZE,
+ CONFIG_SYS_PCIE_MEMSIZE,
PCI_REGION_MEM);
hose->region_count = 1;
pci_register_hose(hose);