rename CFG_ macros to CONFIG_SYS
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
diff --git a/board/etx094/etx094.c b/board/etx094/etx094.c
index 7806519..d6f638a 100644
--- a/board/etx094/etx094.c
+++ b/board/etx094/etx094.c
@@ -127,7 +127,7 @@
phys_size_t initdram (int board_type)
{
- volatile immap_t *immap = (immap_t *) CFG_IMMR;
+ volatile immap_t *immap = (immap_t *) CONFIG_SYS_IMMR;
volatile memctl8xx_t *memctl = &immap->im_memctl;
long int size_b0, size_b1, size8, size9;
@@ -140,7 +140,7 @@
* with two SDRAM banks or four cycles every 31.2 us with one
* bank. It will be adjusted after memory sizing.
*/
- memctl->memc_mptpr = CFG_MPTPR_1BK_4K; /* MPTPR_PTP_DIV32 0x0200 */
+ memctl->memc_mptpr = CONFIG_SYS_MPTPR_1BK_4K; /* MPTPR_PTP_DIV32 0x0200 */
/* A3(SDRAM)=0 => Bursttype = Sequential
* A2-A0(SDRAM)=010 => Burst length = 4
@@ -153,15 +153,15 @@
* preliminary addresses - these have to be modified after the
* SDRAM size has been determined.
*/
- memctl->memc_or2 = CFG_OR2_PRELIM;
- memctl->memc_br2 = CFG_BR2_PRELIM;
+ memctl->memc_or2 = CONFIG_SYS_OR2_PRELIM;
+ memctl->memc_br2 = CONFIG_SYS_BR2_PRELIM;
if (board_type == 0) { /* "L" type boards have only one bank SDRAM */
- memctl->memc_or3 = CFG_OR3_PRELIM;
- memctl->memc_br3 = CFG_BR3_PRELIM;
+ memctl->memc_or3 = CONFIG_SYS_OR3_PRELIM;
+ memctl->memc_br3 = CONFIG_SYS_BR3_PRELIM;
}
- memctl->memc_mamr = CFG_MAMR_8COL & (~(MAMR_PTAE)); /* no refresh yet */
+ memctl->memc_mamr = CONFIG_SYS_MAMR_8COL & (~(MAMR_PTAE)); /* no refresh yet */
udelay (200);
@@ -186,7 +186,7 @@
*
* try 8 column mode
*/
- size8 = dram_size (CFG_MAMR_8COL, (long *) SDRAM_BASE2_PRELIM,
+ size8 = dram_size (CONFIG_SYS_MAMR_8COL, (long *) SDRAM_BASE2_PRELIM,
SDRAM_MAX_SIZE);
udelay (1000);
@@ -194,7 +194,7 @@
/*
* try 9 column mode
*/
- size9 = dram_size (CFG_MAMR_9COL, (long *) SDRAM_BASE2_PRELIM,
+ size9 = dram_size (CONFIG_SYS_MAMR_9COL, (long *) SDRAM_BASE2_PRELIM,
SDRAM_MAX_SIZE);
if (size8 < size9) { /* leave configuration at 9 columns */
@@ -202,7 +202,7 @@
/* debug ("SDRAM Bank 0 in 9 column mode: %ld MB\n", size >> 20); */
} else { /* back to 8 columns */
size_b0 = size8;
- memctl->memc_mamr = CFG_MAMR_8COL;
+ memctl->memc_mamr = CONFIG_SYS_MAMR_8COL;
udelay (500);
/* debug ("SDRAM Bank 0 in 8 column mode: %ld MB\n", size >> 20); */
}
@@ -230,7 +230,7 @@
*/
if ((size_b0 < 0x02000000) && (size_b1 < 0x02000000)) {
/* reduce to 15.6 us (62.4 us / quad) */
- memctl->memc_mptpr = CFG_MPTPR_2BK_4K; /*DIV16 */
+ memctl->memc_mptpr = CONFIG_SYS_MPTPR_2BK_4K; /*DIV16 */
udelay (1000);
}
@@ -239,18 +239,18 @@
*/
if (size_b1 > size_b0) { /* SDRAM Bank 1 is bigger - map first */
- memctl->memc_or3 = ((-size_b1) & 0xFFFF0000) | CFG_OR_TIMING_SDRAM;
+ memctl->memc_or3 = ((-size_b1) & 0xFFFF0000) | CONFIG_SYS_OR_TIMING_SDRAM;
memctl->memc_br3 =
- (CFG_SDRAM_BASE & BR_BA_MSK) | BR_MS_UPMA | BR_V;
+ (CONFIG_SYS_SDRAM_BASE & BR_BA_MSK) | BR_MS_UPMA | BR_V;
if (size_b0 > 0) {
/*
* Position Bank 0 immediately above Bank 1
*/
memctl->memc_or2 =
- ((-size_b0) & 0xFFFF0000) | CFG_OR_TIMING_SDRAM;
+ ((-size_b0) & 0xFFFF0000) | CONFIG_SYS_OR_TIMING_SDRAM;
memctl->memc_br2 =
- ((CFG_SDRAM_BASE & BR_BA_MSK) | BR_MS_UPMA | BR_V)
+ ((CONFIG_SYS_SDRAM_BASE & BR_BA_MSK) | BR_MS_UPMA | BR_V)
+ size_b1;
} else {
unsigned long reg;
@@ -264,24 +264,24 @@
/* adjust refresh rate depending on SDRAM type, one bank */
reg = memctl->memc_mptpr;
- reg >>= 1; /* reduce to CFG_MPTPR_1BK_8K / _4K */
+ reg >>= 1; /* reduce to CONFIG_SYS_MPTPR_1BK_8K / _4K */
memctl->memc_mptpr = reg;
}
} else { /* SDRAM Bank 0 is bigger - map first */
- memctl->memc_or2 = ((-size_b0) & 0xFFFF0000) | CFG_OR_TIMING_SDRAM;
+ memctl->memc_or2 = ((-size_b0) & 0xFFFF0000) | CONFIG_SYS_OR_TIMING_SDRAM;
memctl->memc_br2 =
- (CFG_SDRAM_BASE & BR_BA_MSK) | BR_MS_UPMA | BR_V;
+ (CONFIG_SYS_SDRAM_BASE & BR_BA_MSK) | BR_MS_UPMA | BR_V;
if (size_b1 > 0) {
/*
* Position Bank 1 immediately above Bank 0
*/
memctl->memc_or3 =
- ((-size_b1) & 0xFFFF0000) | CFG_OR_TIMING_SDRAM;
+ ((-size_b1) & 0xFFFF0000) | CONFIG_SYS_OR_TIMING_SDRAM;
memctl->memc_br3 =
- ((CFG_SDRAM_BASE & BR_BA_MSK) | BR_MS_UPMA | BR_V)
+ ((CONFIG_SYS_SDRAM_BASE & BR_BA_MSK) | BR_MS_UPMA | BR_V)
+ size_b0;
} else {
unsigned long reg;
@@ -295,7 +295,7 @@
/* adjust refresh rate depending on SDRAM type, one bank */
reg = memctl->memc_mptpr;
- reg >>= 1; /* reduce to CFG_MPTPR_1BK_8K / _4K */
+ reg >>= 1; /* reduce to CONFIG_SYS_MPTPR_1BK_8K / _4K */
memctl->memc_mptpr = reg;
}
}
@@ -318,7 +318,7 @@
static long int dram_size (long int mamr_value, long int *base,
long int maxsize)
{
- volatile immap_t *immap = (immap_t *) CFG_IMMR;
+ volatile immap_t *immap = (immap_t *) CONFIG_SYS_IMMR;
volatile memctl8xx_t *memctl = &immap->im_memctl;
memctl->memc_mamr = mamr_value;
@@ -343,7 +343,7 @@
unsigned short rd_msk = 0x02A0;
/* HW-ID pin-definition */
- volatile immap_t *immr = (immap_t *) CFG_IMMR;
+ volatile immap_t *immr = (immap_t *) CONFIG_SYS_IMMR;
immr->im_ioport.iop_pddir &= ~(rd_msk);
immr->im_ioport.iop_pdpar &= ~(rd_msk);