rename CFG_ macros to CONFIG_SYS
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
diff --git a/board/siemens/SCM/scm.c b/board/siemens/SCM/scm.c
index 6a9dd25..e0611fe 100644
--- a/board/siemens/SCM/scm.c
+++ b/board/siemens/SCM/scm.c
@@ -249,7 +249,7 @@
*/
maxsize = (1 + (~orx | 0x7fff)) / 2;
- /* Since CFG_SDRAM_BASE is always 0 (??), we assume that
+ /* Since CONFIG_SYS_SDRAM_BASE is always 0 (??), we assume that
* we are configuring CS1 if base != 0
*/
sdmr_ptr = base ? &memctl->memc_lsdmr : &memctl->memc_psdmr;
@@ -274,7 +274,7 @@
* accessing the SDRAM with a single-byte transaction."
*
* The appropriate BRx/ORx registers have already been set when we
- * get here. The SDRAM can be accessed at the address CFG_SDRAM_BASE.
+ * get here. The SDRAM can be accessed at the address CONFIG_SYS_SDRAM_BASE.
*/
*sdmr_ptr = sdmr | PSDMR_OP_PREA;
@@ -285,7 +285,7 @@
*base = c;
*sdmr_ptr = sdmr | PSDMR_OP_MRW;
- *(base + CFG_MRS_OFFS) = c; /* setting MR on address lines */
+ *(base + CONFIG_SYS_MRS_OFFS) = c; /* setting MR on address lines */
*sdmr_ptr = sdmr | PSDMR_OP_NORM | PSDMR_RFEN;
*base = c;
@@ -308,10 +308,10 @@
phys_size_t initdram (int board_type)
{
- volatile immap_t *immap = (immap_t *) CFG_IMMR;
+ volatile immap_t *immap = (immap_t *) CONFIG_SYS_IMMR;
volatile memctl8260_t *memctl = &immap->im_memctl;
-#ifndef CFG_RAMBOOT
+#ifndef CONFIG_SYS_RAMBOOT
long size8, size9;
#endif
long psize, lsize;
@@ -319,8 +319,8 @@
psize = 16 * 1024 * 1024;
lsize = 0;
- memctl->memc_psrt = CFG_PSRT;
- memctl->memc_mptpr = CFG_MPTPR;
+ memctl->memc_psrt = CONFIG_SYS_PSRT;
+ memctl->memc_mptpr = CONFIG_SYS_MPTPR;
#if 0 /* Just for debugging */
#define prt_br_or(brX,orX) do { \
@@ -338,37 +338,37 @@
prt_br_or (br3, or3);
#endif
-#ifndef CFG_RAMBOOT
+#ifndef CONFIG_SYS_RAMBOOT
/* 60x SDRAM setup:
*/
- size8 = try_init (memctl, CFG_PSDMR_8COL, CFG_OR1_8COL,
- (uchar *) CFG_SDRAM_BASE);
- size9 = try_init (memctl, CFG_PSDMR_9COL, CFG_OR1_9COL,
- (uchar *) CFG_SDRAM_BASE);
+ size8 = try_init (memctl, CONFIG_SYS_PSDMR_8COL, CONFIG_SYS_OR1_8COL,
+ (uchar *) CONFIG_SYS_SDRAM_BASE);
+ size9 = try_init (memctl, CONFIG_SYS_PSDMR_9COL, CONFIG_SYS_OR1_9COL,
+ (uchar *) CONFIG_SYS_SDRAM_BASE);
if (size8 < size9) {
psize = size9;
printf ("(60x:9COL - %ld MB, ", psize >> 20);
} else {
- psize = try_init (memctl, CFG_PSDMR_8COL, CFG_OR1_8COL,
- (uchar *) CFG_SDRAM_BASE);
+ psize = try_init (memctl, CONFIG_SYS_PSDMR_8COL, CONFIG_SYS_OR1_8COL,
+ (uchar *) CONFIG_SYS_SDRAM_BASE);
printf ("(60x:8COL - %ld MB, ", psize >> 20);
}
/* Local SDRAM setup:
*/
-#ifdef CFG_INIT_LOCAL_SDRAM
- memctl->memc_lsrt = CFG_LSRT;
- size8 = try_init (memctl, CFG_LSDMR_8COL, CFG_OR2_8COL,
+#ifdef CONFIG_SYS_INIT_LOCAL_SDRAM
+ memctl->memc_lsrt = CONFIG_SYS_LSRT;
+ size8 = try_init (memctl, CONFIG_SYS_LSDMR_8COL, CONFIG_SYS_OR2_8COL,
(uchar *) SDRAM_BASE2_PRELIM);
- size9 = try_init (memctl, CFG_LSDMR_9COL, CFG_OR2_9COL,
+ size9 = try_init (memctl, CONFIG_SYS_LSDMR_9COL, CONFIG_SYS_OR2_9COL,
(uchar *) SDRAM_BASE2_PRELIM);
if (size8 < size9) {
lsize = size9;
printf ("Local:9COL - %ld MB) using ", lsize >> 20);
} else {
- lsize = try_init (memctl, CFG_LSDMR_8COL, CFG_OR2_8COL,
+ lsize = try_init (memctl, CONFIG_SYS_LSDMR_8COL, CONFIG_SYS_OR2_8COL,
(uchar *) SDRAM_BASE2_PRELIM);
printf ("Local:8COL - %ld MB) using ", lsize >> 20);
}
@@ -377,11 +377,11 @@
/* Set up BR2 so that the local SDRAM goes
* right after the 60x SDRAM
*/
- memctl->memc_br2 = (CFG_BR2_PRELIM & ~BRx_BA_MSK) |
- (CFG_SDRAM_BASE + psize);
+ memctl->memc_br2 = (CONFIG_SYS_BR2_PRELIM & ~BRx_BA_MSK) |
+ (CONFIG_SYS_SDRAM_BASE + psize);
#endif
-#endif /* CFG_INIT_LOCAL_SDRAM */
-#endif /* CFG_RAMBOOT */
+#endif /* CONFIG_SYS_INIT_LOCAL_SDRAM */
+#endif /* CONFIG_SYS_RAMBOOT */
icache_enable ();
@@ -394,17 +394,17 @@
static void config_scoh_cs (void)
{
- volatile immap_t *immr = (immap_t *) CFG_IMMR;
+ volatile immap_t *immr = (immap_t *) CONFIG_SYS_IMMR;
volatile memctl8260_t *memctl = &immr->im_memctl;
- volatile can_reg_t *can = (volatile can_reg_t *) CFG_CAN0_BASE;
+ volatile can_reg_t *can = (volatile can_reg_t *) CONFIG_SYS_CAN0_BASE;
volatile uint tmp, i;
/* Initialize OR3 / BR3 for CAN Bus Controller 0 */
- memctl->memc_or3 = CFG_CAN0_OR3;
- memctl->memc_br3 = CFG_CAN0_BR3;
+ memctl->memc_or3 = CONFIG_SYS_CAN0_OR3;
+ memctl->memc_br3 = CONFIG_SYS_CAN0_BR3;
/* Initialize OR4 / BR4 for CAN Bus Controller 1 */
- memctl->memc_or4 = CFG_CAN1_OR4;
- memctl->memc_br4 = CFG_CAN1_BR4;
+ memctl->memc_or4 = CONFIG_SYS_CAN1_OR4;
+ memctl->memc_br4 = CONFIG_SYS_CAN1_BR4;
/* Initialize MAMR to write in the array at address 0x0 */
memctl->memc_mamr = 0x00 | MxMR_OP_WARR | MxMR_GPL_x4DIS;
@@ -487,19 +487,19 @@
/* Initialize OR5 / BR5 for the extended EEPROM Bank0 */
- memctl->memc_or5 = CFG_EXTPROM_OR5;
- memctl->memc_br5 = CFG_EXTPROM_BR5;
+ memctl->memc_or5 = CONFIG_SYS_EXTPROM_OR5;
+ memctl->memc_br5 = CONFIG_SYS_EXTPROM_BR5;
/* Initialize OR6 / BR6 for the extended EEPROM Bank1 */
- memctl->memc_or6 = CFG_EXTPROM_OR6;
- memctl->memc_br6 = CFG_EXTPROM_BR6;
+ memctl->memc_or6 = CONFIG_SYS_EXTPROM_OR6;
+ memctl->memc_br6 = CONFIG_SYS_EXTPROM_BR6;
/* Initialize OR7 / BR7 for the Glue Logic */
- memctl->memc_or7 = CFG_FIOX_OR7;
- memctl->memc_br7 = CFG_FIOX_BR7;
+ memctl->memc_or7 = CONFIG_SYS_FIOX_OR7;
+ memctl->memc_br7 = CONFIG_SYS_FIOX_BR7;
/* Initialize OR8 / BR8 for the DOH Logic */
- memctl->memc_or8 = CFG_FDOHM_OR8;
- memctl->memc_br8 = CFG_FDOHM_BR8;
+ memctl->memc_or8 = CONFIG_SYS_FDOHM_OR8;
+ memctl->memc_br8 = CONFIG_SYS_FDOHM_BR8;
DEBUGF ("OR0 %08x BR0 %08x\n", memctl->memc_or0, memctl->memc_br0);
DEBUGF ("OR1 %08x BR1 %08x\n", memctl->memc_or1, memctl->memc_br1);