rename CFG_ macros to CONFIG_SYS
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
diff --git a/board/sixnet/flash.c b/board/sixnet/flash.c
index 3f23299..a8dfca8 100644
--- a/board/sixnet/flash.c
+++ b/board/sixnet/flash.c
@@ -28,7 +28,7 @@
*/
#include <environment.h>
-flash_info_t flash_info[CFG_MAX_FLASH_BANKS]; /* info for FLASH chips */
+flash_info_t flash_info[CONFIG_SYS_MAX_FLASH_BANKS]; /* info for FLASH chips */
/* NOTE - CONFIG_FLASH_16BIT means the CPU interface is 16-bit, it
* has nothing to do with the flash chip being 8-bit or 16-bit.
@@ -56,7 +56,7 @@
static int write_word_intel(flash_info_t *info, FPWV *dest, FPW data);
static int write_word_amd(flash_info_t *info, FPWV *dest, FPW data);
static void flash_get_offsets(ulong base, flash_info_t *info);
-#ifdef CFG_FLASH_PROTECTION
+#ifdef CONFIG_SYS_FLASH_PROTECTION
static void flash_sync_real_protect(flash_info_t *info);
#endif
@@ -67,17 +67,17 @@
*/
unsigned long flash_init (void)
{
- volatile immap_t *immap = (immap_t *)CFG_IMMR;
+ volatile immap_t *immap = (immap_t *)CONFIG_SYS_IMMR;
volatile memctl8xx_t *memctl = &immap->im_memctl;
unsigned long size_b;
int i;
/* Init: no FLASHes known */
- for (i=0; i < CFG_MAX_FLASH_BANKS; ++i) {
+ for (i=0; i < CONFIG_SYS_MAX_FLASH_BANKS; ++i) {
flash_info[i].flash_id = FLASH_UNKNOWN;
}
- size_b = flash_get_size((FPW *)CFG_FLASH_BASE, &flash_info[0]);
+ size_b = flash_get_size((FPW *)CONFIG_SYS_FLASH_BASE, &flash_info[0]);
flash_info[0].size = size_b;
@@ -91,20 +91,20 @@
/* Do this again (was done already in flast_get_size), just
* in case we move it when remap the FLASH.
*/
- flash_get_offsets (CFG_FLASH_BASE, &flash_info[0]);
+ flash_get_offsets (CONFIG_SYS_FLASH_BASE, &flash_info[0]);
-#ifdef CFG_FLASH_PROTECTION
+#ifdef CONFIG_SYS_FLASH_PROTECTION
/* read the hardware protection status (if any) into the
* protection array in flash_info.
*/
flash_sync_real_protect(&flash_info[0]);
#endif
-#if CFG_MONITOR_BASE >= CFG_FLASH_BASE
+#if CONFIG_SYS_MONITOR_BASE >= CONFIG_SYS_FLASH_BASE
/* monitor protection ON by default */
flash_protect(FLAG_PROTECT_SET,
- CFG_MONITOR_BASE,
- CFG_MONITOR_BASE+monitor_flash_len-1,
+ CONFIG_SYS_MONITOR_BASE,
+ CONFIG_SYS_MONITOR_BASE+monitor_flash_len-1,
&flash_info[0]);
#endif
@@ -405,7 +405,7 @@
return (info->size);
}
-#ifdef CFG_FLASH_PROTECTION
+#ifdef CONFIG_SYS_FLASH_PROTECTION
/*-----------------------------------------------------------------------
*/
@@ -544,7 +544,7 @@
udelay (1000);
while ((*addr & (FPW)0x00800080) != (FPW)0x00800080) {
- if ((now = get_timer(start)) > CFG_FLASH_ERASE_TOUT) {
+ if ((now = get_timer(start)) > CONFIG_SYS_FLASH_ERASE_TOUT) {
printf ("Timeout\n");
if (intel) {
@@ -663,7 +663,7 @@
/* data polling for D7 */
while (res == 0 && (*dest & (FPW)0x00800080) != (data & (FPW)0x00800080)) {
- if (get_timer(start) > CFG_FLASH_WRITE_TOUT) {
+ if (get_timer(start) > CONFIG_SYS_FLASH_WRITE_TOUT) {
*dest = (FPW)0x00F000F0; /* reset bank */
res = 1;
}
@@ -709,7 +709,7 @@
start = get_timer (0);
while (res == 0 && (*dest & (FPW)0x00800080) != (FPW)0x00800080) {
- if (get_timer(start) > CFG_FLASH_WRITE_TOUT) {
+ if (get_timer(start) > CONFIG_SYS_FLASH_WRITE_TOUT) {
*dest = (FPW)0x00B000B0; /* Suspend program */
res = 1;
}
@@ -724,7 +724,7 @@
return (res);
}
-#ifdef CFG_FLASH_PROTECTION
+#ifdef CONFIG_SYS_FLASH_PROTECTION
/*-----------------------------------------------------------------------
*/
int flash_real_protect (flash_info_t * info, long sector, int prot)
diff --git a/board/sixnet/sixnet.c b/board/sixnet/sixnet.c
index dcd3472..3ed581e 100644
--- a/board/sixnet/sixnet.c
+++ b/board/sixnet/sixnet.c
@@ -35,7 +35,7 @@
#if defined(CONFIG_CMD_NAND)
#include <linux/mtd/nand_legacy.h>
-extern struct nand_chip nand_dev_desc[CFG_MAX_NAND_DEVICE];
+extern struct nand_chip nand_dev_desc[CONFIG_SYS_MAX_NAND_DEVICE];
#endif
DECLARE_GLOBAL_DATA_PTR;
@@ -133,7 +133,7 @@
#define FPGA_DONE 0x0080 /* PA8, input, high when FPGA load complete */
#define FPGA_PROGRAM_L 0x0040 /* PA9, output, low to reset, high to start */
#define FPGA_INIT_L 0x0020 /* PA10, input, low indicates not ready */
-#define fpga (*(volatile unsigned char *)(CFG_FPGA_PROG)) /* FPGA port */
+#define fpga (*(volatile unsigned char *)(CONFIG_SYS_FPGA_PROG)) /* FPGA port */
int board_postclk_init (void)
{
@@ -143,7 +143,7 @@
# include "fpgadata.c"
};
- volatile immap_t *immap = (immap_t *)CFG_IMMR;
+ volatile immap_t *immap = (immap_t *)CONFIG_SYS_IMMR;
volatile memctl8xx_t *memctl = &immap->im_memctl;
#define porta (immap->im_ioport.iop_padat)
const unsigned char* pdata;
@@ -247,10 +247,10 @@
/* ------------------------------------------------------------------------- */
/* base address for SRAM, assume 32-bit port, valid */
-#define NVRAM_BR_VALUE (CFG_SRAM_BASE | BR_PS_32 | BR_V)
+#define NVRAM_BR_VALUE (CONFIG_SYS_SRAM_BASE | BR_PS_32 | BR_V)
/* up to 64MB - will be adjusted for actual size */
-#define NVRAM_OR_PRELIM (ORMASK(CFG_SRAM_SIZE) \
+#define NVRAM_OR_PRELIM (ORMASK(CONFIG_SYS_SRAM_SIZE) \
| OR_CSNT_SAM | OR_ACS_DIV4 | OR_BI | OR_SCY_5_CLK | OR_EHTR)
/*
* Miscellaneous platform dependent initializations after running in RAM.
@@ -258,7 +258,7 @@
int misc_init_r (void)
{
- volatile immap_t *immap = (immap_t *)CFG_IMMR;
+ volatile immap_t *immap = (immap_t *)CONFIG_SYS_IMMR;
volatile memctl8xx_t *memctl = &immap->im_memctl;
char* s;
char* e;
@@ -271,7 +271,7 @@
/* Is there any SRAM? Is it 16 or 32 bits wide? */
/* First look for 32-bit SRAM */
- bd->bi_sramsize = ram_size((ulong*)CFG_SRAM_BASE, CFG_SRAM_SIZE);
+ bd->bi_sramsize = ram_size((ulong*)CONFIG_SYS_SRAM_BASE, CONFIG_SYS_SRAM_SIZE);
if (bd->bi_sramsize == 0) {
/* no 32-bit SRAM, but there could be 16-bit SRAM since
@@ -279,7 +279,7 @@
* Try again with a 16-bit bus.
*/
memctl->memc_br2 |= BR_PS_16;
- bd->bi_sramsize = ram_size((ulong*)CFG_SRAM_BASE, CFG_SRAM_SIZE);
+ bd->bi_sramsize = ram_size((ulong*)CONFIG_SYS_SRAM_BASE, CONFIG_SYS_SRAM_SIZE);
}
if (bd->bi_sramsize == 0) {
@@ -288,7 +288,7 @@
else {
/* adjust or2 for actual size of SRAM */
memctl->memc_or2 |= ORMASK(bd->bi_sramsize);
- bd->bi_sramstart = CFG_SRAM_BASE;
+ bd->bi_sramstart = CONFIG_SYS_SRAM_BASE;
printf("SRAM: %lu KB\n", bd->bi_sramsize >> 10);
}
@@ -330,7 +330,7 @@
#if defined(CONFIG_CMD_NAND)
void nand_init(void)
{
- unsigned long totlen = nand_probe(CFG_DFLASH_BASE);
+ unsigned long totlen = nand_probe(CONFIG_SYS_DFLASH_BASE);
printf ("%4lu MB\n", totlen >> 20);
}
@@ -498,7 +498,7 @@
phys_size_t initdram(int board_type)
{
- volatile immap_t *immap = (immap_t *)CFG_IMMR;
+ volatile immap_t *immap = (immap_t *)CONFIG_SYS_IMMR;
volatile memctl8xx_t *memctl = &immap->im_memctl;
uint size_sdram = 0;
uint size_sdram9 = 0;