rename CFG_ macros to CONFIG_SYS
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
diff --git a/doc/README.adnpesc1 b/doc/README.adnpesc1
index 5257f18..f9566b8 100644
--- a/doc/README.adnpesc1
+++ b/doc/README.adnpesc1
@@ -78,7 +78,7 @@
A minimal configuration occupies less than 70 KByte
(network, SPI, POST and board command support disabled). You
can save more memory by deactivating the Hu-Shell support and
-long command help (CFG_HUSH_PARSER, CFG_LONGHELP).
+long command help (CONFIG_SYS_HUSH_PARSER, CONFIG_SYS_LONGHELP).
To program U-Boot into the ADNP/ESC1 flash using GERMS do the
following:
@@ -193,24 +193,24 @@
- this is the startup address for autoboot
- each Nios application code we want to update will be copied
to this address
- - default is CFG_ADNPESC1_NIOS_APPL_ENTRY
+ - default is CONFIG_SYS_ADNPESC1_NIOS_APPL_ENTRY
3. appl_end_addr
- Nios application area end address (usually in Flash)
- will be used to unprotect/erase the Flash area while updating
- - default is CFG_ADNPESC1_NIOS_APPL_END
+ - default is CONFIG_SYS_ADNPESC1_NIOS_APPL_END
4. appl_ident_addr
- address of the Nios application identification string
- this is the address checked-up by autoboot
- - default is CFG_ADNPESC1_NIOS_APPL_IDENT
+ - default is CONFIG_SYS_ADNPESC1_NIOS_APPL_IDENT
5. appl_ident_str
- the Nios application identification string itself
- - default is CFG_ADNPESC1_NIOS_IDENTIFIER
+ - default is CONFIG_SYS_ADNPESC1_NIOS_IDENTIFIER
6. appl_name
@@ -221,13 +221,13 @@
- optionally file system area start address (usually in Flash)
- each file system we want to update will be copied to this address
- - default is CFG_ADNPESC1_FILESYSTEM_BASE
+ - default is CONFIG_SYS_ADNPESC1_FILESYSTEM_BASE
8. fs_end_addr
- optionally file system area end address (usually in Flash)
- will be used to unprotect/erase the Flash area while updating
- - default is CFG_ADNPESC1_FILESYSTEM_END
+ - default is CONFIG_SYS_ADNPESC1_FILESYSTEM_END
9. fs_name