board: ti: k3: Convert boot flow ascii flow to svg
Replace the ascii flow diagram with svg.
Signed-off-by: Nishanth Menon <nm@ti.com>
diff --git a/doc/board/ti/k3.rst b/doc/board/ti/k3.rst
index eb1896b..9d40675 100644
--- a/doc/board/ti/k3.rst
+++ b/doc/board/ti/k3.rst
@@ -45,10 +45,7 @@
including a 32bit U-Boot SPL, (called the wakup SPL) that ROM will jump
to after it has finished loading everything into internal SRAM.
-.. code-block:: text
-
- | WKUP Domain
- ROM -> WKUP SPL ->
+.. image:: img/boot_flow_01.svg
The wakeup SPL, running on a wakeup domain core, will initialize DDR and
any peripherals needed load the larger binaries inside the `tispl.bin`
@@ -57,10 +54,7 @@
starting with Trusted Firmware-A (TF-A), before moving on to start
OP-TEE and the main domain's U-Boot SPL.
-.. code-block:: text
-
- | WKUP Domain | Main Domain ->
- ROM -> WKUP SPL -> TF-A -> OP-TEE -> Main SPL
+.. image:: img/boot_flow_02.svg
The main domain's SPL, running on a 64bit application core, has
virtually unlimited space (billions of bytes now that DDR is working) to
@@ -68,10 +62,7 @@
which loads more firmware into the micro-controller & wakeup domains and
finally prepare the main domain to run Linux.
-.. code-block:: text
-
- | WKUP Domain | Main Domain ->
- ROM -> WKUP SPL -> TF-A -> OP-TEE -> Main SPL -> UBoot -> Linux
+.. image:: img/boot_flow_03.svg
This is the typical boot flow for all K3 based SoCs, however this flow
offers quite a lot in the terms of flexibility, especially on High