rockchip: Move the MMC setup check earlier

When the boot ROM sets up MMC we don't need to do it again. Remove the
MMC setup code entirely.

Signed-off-by: Simon Glass <sjg@chromium.org>
diff --git a/arch/arm/mach-rockchip/rk3288-board-spl.c b/arch/arm/mach-rockchip/rk3288-board-spl.c
index 15f1266..d8c9ca7 100644
--- a/arch/arm/mach-rockchip/rk3288-board-spl.c
+++ b/arch/arm/mach-rockchip/rk3288-board-spl.c
@@ -114,7 +114,6 @@
 #ifdef CONFIG_SPL_MMC_SUPPORT
 static int configure_emmc(struct udevice *pinctrl)
 {
-#if !defined(CONFIG_TARGET_ROCK2) && !defined(CONFIG_TARGET_FIREFLY_RK3288)
 	struct gpio_desc desc;
 	int ret;
 
@@ -144,7 +143,6 @@
 		debug("gpio value ret=%d\n", ret);
 		return ret;
 	}
-#endif
 
 	return 0;
 }
@@ -247,15 +245,18 @@
 		goto err;
 	}
 #ifdef CONFIG_SPL_MMC_SUPPORT
-	ret = pinctrl_request_noflags(pinctrl, PERIPH_ID_SDCARD);
-	if (ret) {
-		debug("%s: Failed to set up SD card\n", __func__);
-		goto err;
-	}
-	ret = configure_emmc(pinctrl);
-	if (ret) {
-		debug("%s: Failed to set up eMMC\n", __func__);
-		goto err;
+	if (!IS_ENABLED(CONFIG_TARGET_ROCK2) &&
+	    !IS_ENABLED(CONFIG_TARGET_FIREFLY_RK3288)) {
+		ret = pinctrl_request_noflags(pinctrl, PERIPH_ID_SDCARD);
+		if (ret) {
+			debug("%s: Failed to set up SD card\n", __func__);
+			goto err;
+		}
+		ret = configure_emmc(pinctrl);
+		if (ret) {
+			debug("%s: Failed to set up eMMC\n", __func__);
+			goto err;
+		}
 	}
 #endif