mpc85xx: Setup QE pinmux for SPI Flash on MPC8569E-MDS boards
SPI Flash (M25P40) is connected to the SPI1 bus, we need a few
qe_iop entries to actually enable SPI1 on these boards.
Signed-off-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/board/freescale/mpc8569mds/mpc8569mds.c b/board/freescale/mpc8569mds/mpc8569mds.c
index 2d07922..7d1d02e 100644
--- a/board/freescale/mpc8569mds/mpc8569mds.c
+++ b/board/freescale/mpc8569mds/mpc8569mds.c
@@ -154,6 +154,12 @@
{5, 10, 2, 0, 3}, /* UART1_CTS_B */
{5, 11, 1, 0, 2}, /* UART1_RTS_B */
+ /* SPI Flash, M25P40 */
+ {4, 27, 3, 0, 1}, /* SPI_MOSI */
+ {4, 28, 3, 0, 1}, /* SPI_MISO */
+ {4, 29, 3, 0, 1}, /* SPI_CLK */
+ {4, 30, 1, 0, 0}, /* SPI_SEL, GPIO */
+
{0, 0, 0, 0, QE_IOP_TAB_END} /* END of table */
};