ARM: dts: sunxi: A13/A31/A23/A33: Sync from Linux v5.18-rc1
Copy the devicetree source for the A10s/A13/GR8, A31(s), and A23/A33/R16
SoCs and all existing boards from the Linux v5.18-rc1 tag.
These changes are combined into one commit due to interdependencies:
- The unit addresses were removed from bitbanged I2C buses, which
drives a Kconfig default change. This affects sun5i-a13-utoo-p66.dts
and sun6i-a31-colombus.dts.
- The pinctrl nodes were renamed, including some used by the shared
header sunxi-reference-design-tablet.dtsi.
To maintain ABI compatibility with existing LTS kernels, one change
moving some IP blocks to the r_intc interrupt controller is excluded.
This effectively reverts Linux commits 994e5818392c and 9fdef3c3d8c2.
This commit renames the file sun8i-r16-nintendo-nes-classic-edition.dts
to sun8i-r16-nintendo-nes-classic.dts to match the Linux tree.
This commit also adds the following new board devicetrees:
- sun5i-a13-licheepi-one.dts
- sun5i-a13-pocketbook-touch-lux-3.dts
- sun5i-gr8-evb.dts
- sun8i-a23-ippo-q8h-v1.2.dts
- sun8i-a23-ippo-q8h-v5.dts
- sun8i-a33-et-q8-v1.6.dts
- sun8i-a33-ippo-q8h-v1.2.dts
- sun8i-r16-nintendo-super-nes-classic.dts
As with the other SoCs, updates of note are conversion of GPIO pull-up
from pinconf to GPIO flags and renaming the detection GPIO properties in
the USB PHY nodes.
Signed-off-by: Samuel Holland <samuel@sholland.org>
diff --git a/arch/arm/dts/sun5i-a13-q8-tablet.dts b/arch/arm/dts/sun5i-a13-q8-tablet.dts
index a89f29f..f9fc1c8 100644
--- a/arch/arm/dts/sun5i-a13-q8-tablet.dts
+++ b/arch/arm/dts/sun5i-a13-q8-tablet.dts
@@ -49,19 +49,13 @@
compatible = "allwinner,q8-a13", "allwinner,sun5i-a13";
panel: panel {
- compatible = "urt,umsh-8596md-t", "simple-panel";
- #address-cells = <1>;
- #size-cells = <0>;
+ compatible = "bananapi,s070wv20-ct16";
+ power-supply = <®_vcc3v3>;
+ enable-gpios = <&axp_gpio 0 GPIO_ACTIVE_HIGH>; /* AXP GPIO0 */
+ backlight = <&backlight>;
- port@0 {
- reg = <0>;
- /* TODO: lcd panel uses axp gpio0 as enable pin */
- backlight = <&backlight>;
- #address-cells = <1>;
- #size-cells = <0>;
-
- panel_input: endpoint@0 {
- reg = <0>;
+ port {
+ panel_input: endpoint {
remote-endpoint = <&tcon0_out_lcd>;
};
};