board: freescale: p1_p2_rdb_pc: Move ifdef for USB/eLBC check to correct place
Whole section about USB/eLBC configuration seems to be P1020 specific. So
add ifdefs to not compile it on other platforms (e.g. P2020).
Signed-off-by: Pali Rohár <pali@kernel.org>
Reviewed-by: Priyanka Jain <priyanka.jain@nxp.com>
diff --git a/board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c b/board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c
index bed2033..6665aa4 100644
--- a/board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c
+++ b/board/freescale/p1_p2_rdb_pc/p1_p2_rdb_pc.c
@@ -359,10 +359,10 @@
#if defined(CONFIG_TARGET_P1020RDB_PD) || defined(CONFIG_TARGET_P1020RDB_PC)
const char *soc_usb_compat = "fsl-usb2-dr";
int usb_err, usb1_off, usb2_off;
-#endif
#if defined(CONFIG_SDCARD) || defined(CONFIG_SPIFLASH)
int err;
#endif
+#endif
ft_cpu_setup(blob, bd);
@@ -380,6 +380,7 @@
fsl_fdt_fixup_dr_usb(blob, bd);
#endif
+#if defined(CONFIG_TARGET_P1020RDB_PD) || defined(CONFIG_TARGET_P1020RDB_PC)
#if defined(CONFIG_SDCARD) || defined(CONFIG_SPIFLASH)
/* Delete eLBC node as it is muxed with USB2 controller */
if (hwconfig("usb2")) {
@@ -401,7 +402,6 @@
}
#endif
-#if defined(CONFIG_TARGET_P1020RDB_PD) || defined(CONFIG_TARGET_P1020RDB_PC)
/* Delete USB2 node as it is muxed with eLBC */
usb1_off = fdt_node_offset_by_compatible(blob, -1,
soc_usb_compat);