pmic:pfuze implement pmic_mode_init
This patch is to implement pmic_mode_init function, and add prototype
in header file.
This function is to set switching mode for pmic buck regulators to
improve system efficiency.
Mode:
OFF: The regulator is switched off and the output voltage is discharged.
PFM: In this mode, the regulator is always in PFM mode, which
is useful at light loads for optimized efficiency.
PWM: In this mode, the regulator is always in PWM mode operation
regardless of load conditions.
APS: In this mode, the regulator moves automatically between
pulse skipping mode and PWM mode depending on load conditions.
Signed-off-by: Peng Fan <Peng.Fan@freescale.com>
Acked-by: Przemyslaw Marczak <p.marczak@samsung.com>
diff --git a/board/freescale/common/pfuze.c b/board/freescale/common/pfuze.c
index 2cd1794..4980bf7 100644
--- a/board/freescale/common/pfuze.c
+++ b/board/freescale/common/pfuze.c
@@ -5,9 +5,47 @@
*/
#include <common.h>
+#include <errno.h>
#include <power/pmic.h>
#include <power/pfuze100_pmic.h>
+int pfuze_mode_init(struct pmic *p, u32 mode)
+{
+ unsigned char offset, i, switch_num;
+ u32 id, ret;
+
+ pmic_reg_read(p, PFUZE100_DEVICEID, &id);
+ id = id & 0xf;
+
+ if (id == 0) {
+ switch_num = 6;
+ offset = PFUZE100_SW1CMODE;
+ } else if (id == 1) {
+ switch_num = 4;
+ offset = PFUZE100_SW2MODE;
+ } else {
+ printf("Not supported, id=%d\n", id);
+ return -EINVAL;
+ }
+
+ ret = pmic_reg_write(p, PFUZE100_SW1ABMODE, mode);
+ if (ret < 0) {
+ printf("Set SW1AB mode error!\n");
+ return ret;
+ }
+
+ for (i = 0; i < switch_num - 1; i++) {
+ ret = pmic_reg_write(p, offset + i * SWITCH_SIZE, mode);
+ if (ret < 0) {
+ printf("Set switch 0x%x mode error!\n",
+ offset + i * SWITCH_SIZE);
+ return ret;
+ }
+ }
+
+ return ret;
+}
+
struct pmic *pfuze_common_init(unsigned char i2cbus)
{
struct pmic *p;