PPC4xx (Sequoia): Fix Ethernet "remote fault" problems
Every now and then a Sequoia board (or equivalent hardware) had
problems connecting to a Gigabit capable network interface.
There were differences in the PHY setup between Linux and U-Boot.
This patch fixes the problem. Apparently "remote fault" is being set,
which signals to some devices (on the other end of the cable) that a
fault has occurred, while other devices ignore it. I believe the RF bit
was causing the issue, but I removed T4 also, to match up with Linux.
Signed-off-by: Mike Nuss <mike@terascala.com>
diff --git a/cpu/ppc4xx/miiphy.c b/cpu/ppc4xx/miiphy.c
index 4216f0b..3978773 100644
--- a/cpu/ppc4xx/miiphy.c
+++ b/cpu/ppc4xx/miiphy.c
@@ -143,9 +143,8 @@
u16 adv;
miiphy_read (devname, addr, PHY_ANAR, &adv);
- adv |= (PHY_ANLPAR_ACK | PHY_ANLPAR_RF | PHY_ANLPAR_T4 |
- PHY_ANLPAR_TXFD | PHY_ANLPAR_TX | PHY_ANLPAR_10FD |
- PHY_ANLPAR_10);
+ adv |= (PHY_ANLPAR_ACK | PHY_ANLPAR_TXFD | PHY_ANLPAR_TX |
+ PHY_ANLPAR_10FD | PHY_ANLPAR_10);
miiphy_write (devname, addr, PHY_ANAR, adv);
miiphy_read (devname, addr, PHY_1000BTCR, &adv);