ARM: uniphier: use $loadaddr for source command
If the "source" command is not given the address, it uses
CONFIG_SYS_LOAD_ADDR, which is compile-time determined.
Using the "loadaddr" environment variable is handier because it is
relocated according to the memory base when CONFIG_POSITION_INDEPENDENT
is enabled.
Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
diff --git a/include/configs/uniphier.h b/include/configs/uniphier.h
index 2986666..b95fb9c 100644
--- a/include/configs/uniphier.h
+++ b/include/configs/uniphier.h
@@ -169,17 +169,17 @@
"ubi part UBI && " \
"ubifsmount ubi0:boot && " \
"ubifsload ${loadaddr} ${script} && " \
- "source\0" \
+ "source $loadaddr\0" \
"norscript=echo Running ${script} from tftp ... && " \
"tftpboot ${script} &&" \
- "source\0" \
+ "source $loadaddr\0" \
"usbscript=usb start && " \
"setenv devtype usb && " \
"setenv devnum 0 && " \
"run loadscript_fat\0" \
"loadscript_fat=echo Running ${script} from ${devtype}${devnum} ... && " \
"load ${devtype} ${devnum}:1 ${loadaddr} ${script} && " \
- "source\0" \
+ "source $loadaddr\0" \
"sramupdate=setexpr tmp_addr $nor_base + 0x50000 &&" \
"tftpboot $tmp_addr $second_image && " \
"setexpr tmp_addr $nor_base + 0x70000 && " \