omap3evm: Fix mechanism to identify board revision
Function omap3_evm_get_revision() - to identify the
board revision was called at end of setup_net_chip().
Board revision can be ascertained only by identifying
the Ethernet chipset - but combining setup operations
with revision detection isn't a good idea. So, moved
the function after call to setup_net_chip().
Function setup_net_chip() should be ideally be called
only when CONFIG_CMD_NET is defined. But this leaves
the board revision "undetected". This patch allows
static definition of revision or default fallback to
the latest revision.
Signed-off-by: Sanjeev Premi <premi@ti.com>
Signed-off-by: Sandeep Paulraj <s-paulraj@ti.com>
diff --git a/board/ti/evm/evm.c b/board/ti/evm/evm.c
index 73330db..09d14f7 100644
--- a/board/ti/evm/evm.c
+++ b/board/ti/evm/evm.c
@@ -46,6 +46,11 @@
static void omap3_evm_get_revision(void)
{
+#if defined(CONFIG_CMD_NET)
+ /*
+ * Board revision can be ascertained only by identifying
+ * the Ethernet chipset.
+ */
unsigned int smsc_id;
/* Ethernet PHY ID is stored at ID_REV register */
@@ -62,6 +67,19 @@
default:
omap3_evm_version = OMAP3EVM_BOARD_GEN_2;
}
+#else
+#if defined(CONFIG_STATIC_BOARD_REV)
+ /*
+ * Look for static defintion of the board revision
+ */
+ omap3_evm_version = CONFIG_STATIC_BOARD_REV;
+#else
+ /*
+ * Fallback to the default above.
+ */
+ omap3_evm_version = OMAP3EVM_BOARD_GEN_2;
+#endif
+#endif /* CONFIG_CMD_NET */
}
#ifdef CONFIG_USB_OMAP3
@@ -110,6 +128,7 @@
#if defined(CONFIG_CMD_NET)
setup_net_chip();
#endif
+ omap3_evm_get_revision();
dieid_num_r();
@@ -163,9 +182,6 @@
writel(GPIO0, &gpio3_base->cleardataout);
udelay(1);
writel(GPIO0, &gpio3_base->setdataout);
-
- /* determine omap3evm revision */
- omap3_evm_get_revision();
}
int board_eth_init(bd_t *bis)