ARM: tegra: use numeric versioning for p2771-0000
The board ID EEPROM and board ID stickers on p2771-0000 will use a numeric
versioning scheme, with version numbers such as 000/100/200/300/400/500.
Within NVIDIA, these versions are also known as A00/A01/A02/A03/A04/B00.
However, that numbering scheme is not easily visible outside of NVIDIA,
and so does not make much sense to use. Convert U-Boot to use the readily
visible numeric scheme.
Also, it turns out that the current A02 DT actually applies to board
versions 000/100/200 (A00..A02). Consequently rename this to 000 not 200
so that all U-Boot builds are named after the first version of the HW they
support.
Signed-off-by: Stephen Warren <swarren@nvidia.com>
Signed-off-by: Tom Warren <twarren@nvidia.com>
diff --git a/configs/p2771-0000-500_defconfig b/configs/p2771-0000-500_defconfig
new file mode 100644
index 0000000..9432a13
--- /dev/null
+++ b/configs/p2771-0000-500_defconfig
@@ -0,0 +1,37 @@
+CONFIG_ARM=y
+CONFIG_TEGRA=y
+CONFIG_TEGRA186=y
+CONFIG_TARGET_P2771_0000=y
+CONFIG_DEFAULT_DEVICE_TREE="tegra186-p2771-0000-500"
+CONFIG_OF_SYSTEM_SETUP=y
+CONFIG_HUSH_PARSER=y
+CONFIG_SYS_PROMPT="Tegra186 (P2771-0000-500) # "
+# CONFIG_CMD_IMI is not set
+# CONFIG_CMD_IMLS is not set
+# CONFIG_CMD_FLASH is not set
+CONFIG_CMD_MMC=y
+CONFIG_CMD_SF=y
+CONFIG_CMD_SPI=y
+CONFIG_CMD_I2C=y
+CONFIG_CMD_USB=y
+# CONFIG_CMD_FPGA is not set
+CONFIG_CMD_GPIO=y
+# CONFIG_CMD_SETEXPR is not set
+CONFIG_CMD_DHCP=y
+# CONFIG_CMD_NFS is not set
+CONFIG_CMD_MII=y
+CONFIG_CMD_PING=y
+CONFIG_CMD_EXT2=y
+CONFIG_CMD_EXT4=y
+CONFIG_CMD_EXT4_WRITE=y
+CONFIG_CMD_FAT=y
+CONFIG_CMD_FS_GENERIC=y
+CONFIG_RTL8169=y
+CONFIG_E1000=y
+CONFIG_PCI_TEGRA=y
+CONFIG_TEGRA186_BPMP_I2C=y
+CONFIG_SYS_NS16550=y
+CONFIG_USB=y
+CONFIG_DM_USB=y
+CONFIG_POWER_DOMAIN=y
+CONFIG_TEGRA186_POWER_DOMAIN=y