spi: fsl_qspi: Fix DDR mode setting for latest iMX platforms
On latest iMX platforms like iMX7D/iMX6UL/iMX8MQ, the QSPI controller
is updated to have TDH field in FLSHCR register. According to reference
manual, this TDH must be set to 1 when DDR_EN is set. Otherwise, the TX
DDR delay logic won't be enabled.
Another issue in DDR mode is the MCR register will be overwritten in
every read/write/erase operation. This causes DDR_EN been cleared while
TDH=1, then no clk2x output for TX data shift and all operations will
fail.
Signed-off-by: Ye Li <ye.li@nxp.com>
diff --git a/drivers/spi/fsl_qspi.c b/drivers/spi/fsl_qspi.c
index 41abe19..e877d99 100644
--- a/drivers/spi/fsl_qspi.c
+++ b/drivers/spi/fsl_qspi.c
@@ -399,7 +399,7 @@
qspi_write32(priv->flags, ®s->mcr,
QSPI_MCR_CLR_RXF_MASK | QSPI_MCR_CLR_TXF_MASK |
- QSPI_MCR_RESERVED_MASK | QSPI_MCR_END_CFD_LE);
+ mcr_reg);
rx_addr = (void *)(uintptr_t)(priv->cur_amba_base + priv->sf_addr);
/* Read out the data directly from the AHB buffer. */
@@ -429,6 +429,14 @@
reg |= BIT(29);
qspi_write32(priv->flags, ®s->mcr, reg);
+
+ /* Enable the TDH to 1 for some platforms like imx6ul, imx7d, etc
+ * These two bits are reserved on other platforms
+ */
+ reg = qspi_read32(priv->flags, ®s->flshcr);
+ reg &= ~(BIT(17));
+ reg |= BIT(16);
+ qspi_write32(priv->flags, ®s->flshcr, reg);
}
/*
@@ -482,7 +490,7 @@
mcr_reg = qspi_read32(priv->flags, ®s->mcr);
qspi_write32(priv->flags, ®s->mcr,
QSPI_MCR_CLR_RXF_MASK | QSPI_MCR_CLR_TXF_MASK |
- QSPI_MCR_RESERVED_MASK | QSPI_MCR_END_CFD_LE);
+ mcr_reg);
qspi_write32(priv->flags, ®s->rbct, QSPI_RBCT_RXBRD_USEIPS);
qspi_write32(priv->flags, ®s->sfar, priv->cur_amba_base);
@@ -527,7 +535,7 @@
mcr_reg = qspi_read32(priv->flags, ®s->mcr);
qspi_write32(priv->flags, ®s->mcr,
QSPI_MCR_CLR_RXF_MASK | QSPI_MCR_CLR_TXF_MASK |
- QSPI_MCR_RESERVED_MASK | QSPI_MCR_END_CFD_LE);
+ mcr_reg);
qspi_write32(priv->flags, ®s->rbct, QSPI_RBCT_RXBRD_USEIPS);
qspi_write32(priv->flags, ®s->sfar, priv->cur_amba_base);
@@ -573,7 +581,7 @@
mcr_reg = qspi_read32(priv->flags, ®s->mcr);
qspi_write32(priv->flags, ®s->mcr,
QSPI_MCR_CLR_RXF_MASK | QSPI_MCR_CLR_TXF_MASK |
- QSPI_MCR_RESERVED_MASK | QSPI_MCR_END_CFD_LE);
+ mcr_reg);
qspi_write32(priv->flags, ®s->rbct, QSPI_RBCT_RXBRD_USEIPS);
to_or_from = priv->sf_addr + priv->cur_amba_base;
@@ -625,7 +633,7 @@
mcr_reg = qspi_read32(priv->flags, ®s->mcr);
qspi_write32(priv->flags, ®s->mcr,
QSPI_MCR_CLR_RXF_MASK | QSPI_MCR_CLR_TXF_MASK |
- QSPI_MCR_RESERVED_MASK | QSPI_MCR_END_CFD_LE);
+ mcr_reg);
qspi_write32(priv->flags, ®s->rbct, QSPI_RBCT_RXBRD_USEIPS);
status_reg = 0;
@@ -700,7 +708,7 @@
mcr_reg = qspi_read32(priv->flags, ®s->mcr);
qspi_write32(priv->flags, ®s->mcr,
QSPI_MCR_CLR_RXF_MASK | QSPI_MCR_CLR_TXF_MASK |
- QSPI_MCR_RESERVED_MASK | QSPI_MCR_END_CFD_LE);
+ mcr_reg);
qspi_write32(priv->flags, ®s->rbct, QSPI_RBCT_RXBRD_USEIPS);
qspi_write32(priv->flags, ®s->sfar, priv->cur_amba_base);
@@ -737,7 +745,7 @@
mcr_reg = qspi_read32(priv->flags, ®s->mcr);
qspi_write32(priv->flags, ®s->mcr,
QSPI_MCR_CLR_RXF_MASK | QSPI_MCR_CLR_TXF_MASK |
- QSPI_MCR_RESERVED_MASK | QSPI_MCR_END_CFD_LE);
+ mcr_reg);
qspi_write32(priv->flags, ®s->rbct, QSPI_RBCT_RXBRD_USEIPS);
to_or_from = priv->sf_addr + priv->cur_amba_base;
@@ -867,7 +875,6 @@
static int fsl_qspi_probe(struct udevice *bus)
{
- u32 mcr_val;
u32 amba_size_per_chip;
struct fsl_qspi_platdata *plat = dev_get_platdata(bus);
struct fsl_qspi_priv *priv = dev_get_priv(bus);
@@ -900,15 +907,9 @@
return ret;
}
- mcr_val = qspi_read32(priv->flags, &priv->regs->mcr);
-
- /* Set endianness to LE for i.mx */
- if (IS_ENABLED(CONFIG_MX6) || IS_ENABLED(CONFIG_MX7))
- mcr_val = QSPI_MCR_END_CFD_LE;
-
qspi_write32(priv->flags, &priv->regs->mcr,
QSPI_MCR_RESERVED_MASK | QSPI_MCR_MDIS_MASK |
- (mcr_val & QSPI_MCR_END_CFD_MASK));
+ QSPI_MCR_END_CFD_LE);
qspi_cfg_smpr(priv, ~(QSPI_SMPR_FSDLY_MASK | QSPI_SMPR_DDRSMP_MASK |
QSPI_SMPR_FSPHS_MASK | QSPI_SMPR_HSENA_MASK), 0);