configs: j721e_evm_a72_defconfig: Switch to bootstd
Switch to using bootstd. Note with this change, we will stop using
distro_bootcmd and instead depend entirely on bootflow method of
starting the system up.
Signed-off-by: Nishanth Menon <nm@ti.com>
Reviewed-by: Neha Malcom Francis <n-francis@ti.com>
diff --git a/configs/j721e_evm_a72_defconfig b/configs/j721e_evm_a72_defconfig
index 1d043f2..82fa1b1 100644
--- a/configs/j721e_evm_a72_defconfig
+++ b/configs/j721e_evm_a72_defconfig
@@ -29,10 +29,11 @@
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
CONFIG_SPL_LOAD_FIT=y
CONFIG_SPL_LOAD_FIT_ADDRESS=0x81000000
-CONFIG_DISTRO_DEFAULTS=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_OF_SYSTEM_SETUP=y
-CONFIG_BOOTCOMMAND="run envboot; run distro_bootcmd;"
+CONFIG_BOOTSTD_FULL=y
+CONFIG_BOOTSTD_DEFAULTS=y
+CONFIG_BOOTCOMMAND="run envboot; bootflow scan -lb"
CONFIG_LOGLEVEL=7
CONFIG_SPL_MAX_SIZE=0xc0000
CONFIG_SPL_HAS_BSS_LINKER_SECTION=y