ARM: DRA: Enable VTT regulator
DRA7 evm REV G and later boards uses a vtt regulator for DDR3 termination
and this is controlled by gpio7_11. Configuring gpio7_11.
The pad A22(offset 0x3b4) is used by gpio7_11 on REV G and later boards,
and left unused on previous boards, so it is safe enough to enable gpio
on all DRA7 boards.
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
diff --git a/board/ti/dra7xx/evm.c b/board/ti/dra7xx/evm.c
index ae50d88..5592fc5 100644
--- a/board/ti/dra7xx/evm.c
+++ b/board/ti/dra7xx/evm.c
@@ -13,6 +13,8 @@
#include <common.h>
#include <palmas.h>
#include <sata.h>
+#include <asm/gpio.h>
+#include <asm/arch/gpio.h>
#include <asm/arch/sys_proto.h>
#include <asm/arch/mmc_host_def.h>
#include <asm/arch/sata.h>
@@ -26,6 +28,9 @@
DECLARE_GLOBAL_DATA_PTR;
+/* GPIO 7_11 */
+#define GPIO_DDR_VTT_EN 203
+
const struct omap_sysinfo sysinfo = {
"Board: DRA7xx\n"
};
@@ -272,3 +277,29 @@
return ret;
}
#endif
+
+#ifdef CONFIG_BOARD_EARLY_INIT_F
+/* VTT regulator enable */
+static inline void vtt_regulator_enable(void)
+{
+ if (omap_hw_init_context() == OMAP_INIT_CONTEXT_UBOOT_AFTER_SPL)
+ return;
+
+ /* Do not enable VTT for DRA722 */
+ if (omap_revision() == DRA722_ES1_0)
+ return;
+
+ /*
+ * EVM Rev G and later use gpio7_11 for DDR3 termination.
+ * This is safe enough to do on older revs.
+ */
+ gpio_request(GPIO_DDR_VTT_EN, "ddr_vtt_en");
+ gpio_direction_output(GPIO_DDR_VTT_EN, 1);
+}
+
+int board_early_init_f(void)
+{
+ vtt_regulator_enable();
+ return 0;
+}
+#endif
diff --git a/board/ti/dra7xx/mux_data.h b/board/ti/dra7xx/mux_data.h
index 5bc4fc9..7276014 100644
--- a/board/ti/dra7xx/mux_data.h
+++ b/board/ti/dra7xx/mux_data.h
@@ -139,5 +139,6 @@
{GPMC_CS3, (IEN | PTU | PDIS | M1)}, /* QSPI1_CS1*/
#endif /* CONFIG_NAND || CONFIG_NOR */
{USB2_DRVVBUS, (M0 | IEN | FSC) },
+ {SPI1_CS1, (PEN | IDIS | M14) },
};
#endif /* _MUX_DATA_DRA7XX_H_ */