doc: rockchip: Document eMMC program steps
Document eMMC partition creation and program steps for
rockchip platforms.
Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
Reviewed-by: Kever Yang <kever.yang@rock-chips.com>
diff --git a/doc/board/rockchip/rockchip.rst b/doc/board/rockchip/rockchip.rst
index cd9c8d6..1faa675 100644
--- a/doc/board/rockchip/rockchip.rst
+++ b/doc/board/rockchip/rockchip.rst
@@ -117,14 +117,42 @@
sudo dd if=u-boot-rockchip.bin of=/dev/sda seek=64
sync
+eMMC
+^^^^
+
+eMMC flash would probe on mmc0 in most of the rockchip platforms.
+
+Create GPT partition layout as defined in configurations::
+
+ mmc dev 0
+ gpt write mmc 0 $partitions
+
+Connect the USB-OTG cable between host and target device.
+
+Launch fastboot at target::
+
+ fastboot 0
+
+Upon successful gadget connection,host show the USB device like::
+
+ lsusb
+ Bus 001 Device 020: ID 2207:330c Fuzhou Rockchip Electronics Company RK3399 in Mask ROM mode
+
+Program the flash::
+
+ sudo fastboot -i 0x2207 flash loader1 idbloader.img
+ sudo fastboot -i 0x2207 flash loader2 u-boot.itb
+
+Note: for rockchip 32-bit platforms the U-Boot proper image
+is u-boot-dtb.img
+
TODO
----
- Add rockchip idbloader image building
- Add rockchip TPL image building
- Document SPI flash boot
-- Describe steps for eMMC flashing
- Add missing SoC's with it boards list
.. Jagan Teki <jagan@amarulasolutions.com>
-.. Fri Jan 10 00:08:40 IST 2020
+.. Sunday 24 May 2020 10:08:41 PM IST