net: Add support for Marvell 88E1510 PHY
Support the 88E1510 PHY which is very similar to the 88E1518.
I also set the INTn output and configured the LEDs.
Signed-off-by: Clemens Gruber <clemens.gruber@pqgruber.com>
Cc: Joe Hershberger <joe.hershberger@ni.com>
Cc: Hao Zhang <hzhang@ti.com>
Cc: Michal Simek <michal.simek@xilinx.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
diff --git a/drivers/net/phy/marvell.c b/drivers/net/phy/marvell.c
index cff5c87..eab1558 100644
--- a/drivers/net/phy/marvell.c
+++ b/drivers/net/phy/marvell.c
@@ -336,6 +336,25 @@
return m88e1111s_config(phydev);
}
+/* Marvell 88E1510 */
+static int m88e1510_config(struct phy_device *phydev)
+{
+ /* Select page 3 */
+ phy_write(phydev, MDIO_DEVAD_NONE, 22, 3);
+
+ /* Enable INTn output on LED[2] */
+ m88e1518_phy_writebits(phydev, 18, 7, 1, 1);
+
+ /* Configure LEDs */
+ m88e1518_phy_writebits(phydev, 16, 0, 4, 3); /* LED[0]:0011 (ACT) */
+ m88e1518_phy_writebits(phydev, 16, 4, 4, 6); /* LED[1]:0110 (LINK) */
+
+ /* Reset page selection */
+ phy_write(phydev, MDIO_DEVAD_NONE, 22, 0);
+
+ return m88e1518_config(phydev);
+}
+
/* Marvell 88E1118 */
static int m88e1118_config(struct phy_device *phydev)
{
@@ -548,6 +567,16 @@
.shutdown = &genphy_shutdown,
};
+static struct phy_driver M88E1510_driver = {
+ .name = "Marvell 88E1510",
+ .uid = 0x1410dd0,
+ .mask = 0xffffff0,
+ .features = PHY_GBIT_FEATURES,
+ .config = &m88e1510_config,
+ .startup = &m88e1011s_startup,
+ .shutdown = &genphy_shutdown,
+};
+
static struct phy_driver M88E1518_driver = {
.name = "Marvell 88E1518",
.uid = 0x1410dd1,
@@ -578,6 +607,7 @@
phy_register(&M88E1118R_driver);
phy_register(&M88E1111S_driver);
phy_register(&M88E1011S_driver);
+ phy_register(&M88E1510_driver);
phy_register(&M88E1518_driver);
return 0;