Convert CONFIG_SYS_I2C_EEPROM_ADDR et al to Kconfig
- Rename usages of CONFIG_SYS_DEF_EEPROM_ADDR to CONFIG_SYS_I2C_EEPROM_ADDR
based on current usage.
- Convert CONFIG_SYS_I2C_EEPROM_ADDR, CONFIG_SYS_I2C_EEPROM_ADDR_LEN,
CONFIG_SYS_I2C_EEPROM_BUS, CONFIG_CONFIG_SYS_EEPROM_SIZE
CONFIG_SYS_EEPROM_PAGE_WRITE_BITS and CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS
to Kconfig. We move these symbols around a bit and add appropriate
dependencies to them. In some cases, we now add a correct default value
as well.
Signed-off-by: Tom Rini <trini@konsulko.com>
diff --git a/cmd/Kconfig b/cmd/Kconfig
index ffef3cc..41aba38 100644
--- a/cmd/Kconfig
+++ b/cmd/Kconfig
@@ -614,6 +614,37 @@
Help printed with the LAYOUT VERSIONS part of the 'eeprom'
command's help.
+config SYS_I2C_EEPROM_BUS
+ int "I2C bus of the EEPROM device."
+ depends on CMD_EEPROM
+ default 0
+
+config SYS_I2C_EEPROM_ADDR_LEN
+ int "Length in bytes of the EEPROM memory array address"
+ depends on CMD_EEPROM || ID_EEPROM
+ default 1
+ range 1 2
+ help
+ Note: This is NOT the chip address length!
+
+config SYS_EEPROM_SIZE
+ depends on CMD_EEPROM
+ int "Size in bytes of the EEPROM device"
+ default 256
+
+config SYS_EEPROM_PAGE_WRITE_BITS
+ int "Number of bits used to address bytes in a single page"
+ depends on CMD_EEPROM
+ default 8
+ help
+ The EEPROM page size is 2^SYS_EEPROM_PAGE_WRITE_BITS.
+ A 64 byte page, for example would require six bits.
+
+config SYS_EEPROM_PAGE_WRITE_DELAY_MS
+ int "Number of milliseconds to delay between page writes"
+ depends on CMD_EEPROM || CMD_I2C
+ default 0
+
config LOOPW
bool "loopw"
help