Convert CONFIG_SYS_I2C_EEPROM_ADDR et al to Kconfig
- Rename usages of CONFIG_SYS_DEF_EEPROM_ADDR to CONFIG_SYS_I2C_EEPROM_ADDR
based on current usage.
- Convert CONFIG_SYS_I2C_EEPROM_ADDR, CONFIG_SYS_I2C_EEPROM_ADDR_LEN,
CONFIG_SYS_I2C_EEPROM_BUS, CONFIG_CONFIG_SYS_EEPROM_SIZE
CONFIG_SYS_EEPROM_PAGE_WRITE_BITS and CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS
to Kconfig. We move these symbols around a bit and add appropriate
dependencies to them. In some cases, we now add a correct default value
as well.
Signed-off-by: Tom Rini <trini@konsulko.com>
diff --git a/drivers/misc/Kconfig b/drivers/misc/Kconfig
index 997b713..099ff29 100644
--- a/drivers/misc/Kconfig
+++ b/drivers/misc/Kconfig
@@ -398,36 +398,12 @@
This option is an SPL-variant of the I2C_EEPROM option.
See the help of I2C_EEPROM for details.
-if I2C_EEPROM
-
config SYS_I2C_EEPROM_ADDR
hex "Chip address of the EEPROM device"
+ depends on ID_EEPROM || I2C_EEPROM || SPL_I2C_EEPROM || CMD_EEPROM || ENV_IS_IN_EEPROM
default 0
-config SYS_I2C_EEPROM_BUS
- int "I2C bus of the EEPROM device."
- default 0
-
-config SYS_EEPROM_SIZE
- int "Size in bytes of the EEPROM device"
- default 256
-
-config SYS_EEPROM_PAGE_WRITE_BITS
- int "Number of bits used to address bytes in a single page"
- default 0
- help
- The EEPROM page size is 2^SYS_EEPROM_PAGE_WRITE_BITS.
- A 64 byte page, for example would require six bits.
-
-config SYS_EEPROM_PAGE_WRITE_DELAY_MS
- int "Number of milliseconds to delay between page writes"
- default 0
-
-config SYS_I2C_EEPROM_ADDR_LEN
- int "Length in bytes of the EEPROM memory array address"
- default 1
- help
- Note: This is NOT the chip address length!
+if I2C_EEPROM
config SYS_I2C_EEPROM_ADDR_OVERFLOW
hex "EEPROM Address Overflow"