imx: mx6ul_14x14_evk: Fix SPL boot
When booting SPL on the board, met boot failure:
"
Trying to boot from MMC2
MMC Device 1 not found
spl: could not find mmc device 1. error: -19
SPL: failed to boot from all boot devices
"
Let's register the two mmc controllers in SPL stage to
avoid boot failure.
Signed-off-by: Peng Fan <peng.fan@nxp.com>
Reviewed-by: Fabio Estevam <festevam@gmail.com>
diff --git a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
index ccbe404..32f3912 100644
--- a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
+++ b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
@@ -111,7 +111,6 @@
MX6_PAD_UART1_RX_DATA__UART1_DCE_RX | MUX_PAD_CTRL(UART_PAD_CTRL),
};
-#ifndef CONFIG_SPL_BUILD
static iomux_v3_cfg_t const usdhc1_pads[] = {
MX6_PAD_SD1_CLK__USDHC1_CLK | MUX_PAD_CTRL(USDHC_PAD_CTRL),
MX6_PAD_SD1_CMD__USDHC1_CMD | MUX_PAD_CTRL(USDHC_PAD_CTRL),
@@ -127,7 +126,6 @@
/* RST_B */
MX6_PAD_GPIO1_IO09__GPIO1_IO09 | MUX_PAD_CTRL(NO_PAD_CTRL),
};
-#endif
/*
* mx6ul_14x14_evk board default supports sd card. If want to use
@@ -238,19 +236,6 @@
int board_mmc_init(bd_t *bis)
{
-#ifdef CONFIG_SPL_BUILD
-#if defined(CONFIG_MX6UL_14X14_EVK_EMMC_REWORK)
- imx_iomux_v3_setup_multiple_pads(usdhc2_emmc_pads,
- ARRAY_SIZE(usdhc2_emmc_pads));
-#else
- imx_iomux_v3_setup_multiple_pads(usdhc2_pads, ARRAY_SIZE(usdhc2_pads));
-#endif
- gpio_direction_output(USDHC2_PWR_GPIO, 0);
- udelay(500);
- gpio_direction_output(USDHC2_PWR_GPIO, 1);
- usdhc_cfg[1].sdhc_clk = mxc_get_clock(MXC_ESDHC2_CLK);
- return fsl_esdhc_initialize(bis, &usdhc_cfg[1]);
-#else
int i, ret;
/*
@@ -297,7 +282,6 @@
return ret;
}
}
-#endif
return 0;
}
#endif