mmc: tmio: sdhi: Configure internal DMA bus width
The R-Car3 SDHI should set these two bits in DMA_MODE register according
to the specification, to indicate 64bit bus width. No other bus width
options are permitted and the default value is 0, which is incorrect.
Set the bits accordingly.
Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>
diff --git a/drivers/mmc/tmio-common.h b/drivers/mmc/tmio-common.h
index 9062300..59d5a0e 100644
--- a/drivers/mmc/tmio-common.h
+++ b/drivers/mmc/tmio-common.h
@@ -90,6 +90,7 @@
#define TMIO_SD_VOLT_180 (2 << 0)/* 1.8V signal */
#define TMIO_SD_DMA_MODE 0x410
#define TMIO_SD_DMA_MODE_DIR_RD BIT(16) /* 1: from device, 0: to dev */
+#define TMIO_SD_DMA_MODE_BUS_WIDTH (BIT(5) | BIT(4)) /* RCar, 64bit */
#define TMIO_SD_DMA_MODE_ADDR_INC BIT(0) /* 1: address inc, 0: fixed */
#define TMIO_SD_DMA_CTL 0x414
#define TMIO_SD_DMA_CTL_START BIT(0) /* start DMA (auto cleared) */
@@ -121,6 +122,7 @@
unsigned int version;
u32 caps;
u32 read_poll_flag;
+ u32 idma_bus_width;
#define TMIO_SD_CAP_NONREMOVABLE BIT(0) /* Nonremovable e.g. eMMC */
#define TMIO_SD_CAP_DMA_INTERNAL BIT(1) /* have internal DMA engine */
#define TMIO_SD_CAP_DIV1024 BIT(2) /* divisor 1024 is available */