tegra: fdt: Add additional USB binding
This adds a property to indicate a port which can switch between host and device
mode.
Signed-off-by: Simon Glass <sjg@chromium.org>
Acked-by: Stephen Warren <swarren@nvidia.com>
Signed-off-by: Tom Warren <twarren@nvidia.com>
diff --git a/doc/device-tree-bindings/usb/tegra-usb.txt b/doc/device-tree-bindings/usb/tegra-usb.txt
index 035d63d..5282d44 100644
--- a/doc/device-tree-bindings/usb/tegra-usb.txt
+++ b/doc/device-tree-bindings/usb/tegra-usb.txt
@@ -11,3 +11,15 @@
- phy_type : Should be one of "ulpi" or "utmi".
- nvidia,vbus-gpio : If present, specifies a gpio that needs to be
activated for the bus to be powered.
+
+Optional properties:
+ - dr_mode : dual role mode. Indicates the working mode for
+ nvidia,tegra20-ehci compatible controllers. Can be "host", "peripheral",
+ or "otg". Default to "host" if not defined for backward compatibility.
+ host means this is a host controller
+ peripheral means it is device controller
+ otg means it can operate as either ("on the go")
+ - nvidia,has-legacy-mode : boolean indicates whether this controller can
+ operate in legacy mode (as APX 2500 / 2600). In legacy mode some
+ registers are accessed through the APB_MISC base address instead of
+ the USB controller.