arm: xea: Modify board code to generate single binary u-boot
This change provides the possibility to build XEA (imx287 based) board
U-Boot as a single binary (without support for CONFIG_SPL_FRAMEWORK).
The generated u-boot.sb can be used in the factory environment to for
example perform initial setup or HW testing.
It can be used with 'uuu' utility
(SDPS: boot -f /srv/tftp/xea/u-boot.sb)
In the configs/imx28_xea_defconfig one needs to disable following configs:
# CONFIG_SPL_BLK is not set
# CONFIG_SPL_FRAMEWORK is not set
The board_init_ll() is used in arch/arm/cpu/arm926ejs/mxs/start.S, which
is utilized when CONFIG_SPL_FRAMEWORK is disabled.
However, when it is enabled - the arch/arm/cpu/arm926ejs/start.S is used,
which requires the lowlevel_init() function.
Signed-off-by: Lukasz Majewski <lukma@denx.de>
diff --git a/board/liebherr/xea/spl_xea.c b/board/liebherr/xea/spl_xea.c
index 192f68f..df354ca 100644
--- a/board/liebherr/xea/spl_xea.c
+++ b/board/liebherr/xea/spl_xea.c
@@ -290,6 +290,12 @@
0x00000000, 0xffffffff
};
+#ifndef CONFIG_SPL_FRAMEWORK
+void board_init_ll(const u32 arg, const uint32_t *resptr)
+{
+ mxs_common_spl_init(arg, resptr, iomux_setup, ARRAY_SIZE(iomux_setup));
+}
+#else
void lowlevel_init(void)
{
struct mxs_pinctrl_regs *pinctrl_regs =
@@ -301,3 +307,4 @@
mxs_common_spl_init(0, NULL, iomux_setup, ARRAY_SIZE(iomux_setup));
}
+#endif
diff --git a/board/liebherr/xea/xea.c b/board/liebherr/xea/xea.c
index cd11b0a..38e841c 100644
--- a/board/liebherr/xea/xea.c
+++ b/board/liebherr/xea/xea.c
@@ -58,7 +58,7 @@
mxs_set_sspclk(MXC_SSPCLK3, 96000, 0);
}
-#ifdef CONFIG_SPL_BUILD
+#if defined(CONFIG_SPL_BUILD) && defined(CONFIG_SPL_FRAMEWORK)
void board_init_f(ulong arg)
{
init_clocks();