| # Defconfig fragment to apply on top of am62x_evm_a53_defconfig |
| |
| CONFIG_DEFAULT_DEVICE_TREE="k3-am625-beagleplay" |
| CONFIG_OF_LIST="k3-am625-beagleplay" |
| CONFIG_SPL_OF_LIST="k3-am625-beagleplay" |
| CONFIG_BOOTCOMMAND="run set_led_state_start_load;run findfdt; run envboot; bootflow scan -lb;run set_led_state_fail_load" |
| CONFIG_EXT4_WRITE=y |
| CONFIG_LZO=y |
| CONFIG_AUTOBOOT_KEYED=y |
| CONFIG_AUTOBOOT_PROMPT="Press SPACE to abort autoboot in %d seconds\n" |
| CONFIG_AUTOBOOT_DELAY_STR="d" |
| CONFIG_AUTOBOOT_STOP_STR=" " |
| # Use the Beagleplay env file |
| CONFIG_ENV_SOURCE_FILE="beagleplay" |
| # Do not use emmc boot - we will use FS only |
| CONFIG_SUPPORT_EMMC_BOOT=n |
| CONFIG_MMC_IO_VOLTAGE=y |
| # CONFIG_SPL_MMC_IO_VOLTAGE is not set |
| CONFIG_MMC_UHS_SUPPORT=y |
| # CONFIG_SPL_MMC_UHS_SUPPORT is not set |
| CONFIG_MMC_HS200_SUPPORT=y |
| # CONFIG_SPL_MMC_HS200_SUPPORT is not set |
| # Enable GPIO control |
| CONFIG_DM_GPIO=y |
| CONFIG_SPL_GPIO=y |
| CONFIG_DA8XX_GPIO=y |
| CONFIG_CMD_GPIO=y |
| CONFIG_CMD_GPIO_READ=y |
| # Enable LEDs |
| CONFIG_LED=y |
| CONFIG_LED_GPIO=y |
| CONFIG_SPL_LED=y |
| CONFIG_SPL_LED_GPIO=y |
| # Enable I2C bus |
| CONFIG_SPL_I2C=y |
| CONFIG_DM_I2C=y |
| CONFIG_SYS_I2C_OMAP24XX=y |
| CONFIG_CMD_I2C=y |
| # Regulator |
| CONFIG_DM_REGULATOR=y |
| CONFIG_DM_REGULATOR_FIXED=y |
| CONFIG_DM_REGULATOR_GPIO=y |
| CONFIG_CMD_REGULATOR=y |
| CONFIG_DM_REGULATOR_TPS65219=y |
| CONFIG_DM_PMIC=y |
| CONFIG_PMIC_TPS65219=y |
| CONFIG_CMD_PMIC=y |
| # Uses Realtek phy rather than TI phy |
| CONFIG_PHY_TI_DP83867=n |
| CONFIG_PHY_REALTEK=y |
| # No SPI flash on Beagleplay |
| CONFIG_SPI=n |
| CONFIG_SPI_FLASH=n |
| CONFIG_SPL_DM_SPI_FLASH=n |
| CONFIG_SPL_SPI_FLASH_SUPPORT=n |