miiphy: convert to linux/mii.h
The include/miiphy.h header duplicates a lot of things from linux/mii.h.
So punt all the things that overlap to keep the API simple and to make
merging between U-Boot and Linux simpler.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
diff --git a/board/evb64260/eth.c b/board/evb64260/eth.c
index a96e655..352505a 100644
--- a/board/evb64260/eth.c
+++ b/board/evb64260/eth.c
@@ -422,24 +422,24 @@
static void
check_phy_state(struct eth_dev_s *p)
{
- int bmsr = miiphy_read_ret(ether_port_phy_addr[p->dev], PHY_BMSR);
+ int bmsr = miiphy_read_ret(ether_port_phy_addr[p->dev], MII_BMSR);
int psr = GTREGREAD(ETHERNET0_PORT_STATUS_REGISTER + p->reg_base);
- if ((psr & 1<<3) && (bmsr & PHY_BMSR_LS)) {
- int nego = miiphy_read_ret(ether_port_phy_addr[p->dev], PHY_ANAR) &
- miiphy_read_ret(ether_port_phy_addr[p->dev], PHY_ANLPAR);
+ if ((psr & 1<<3) && (bmsr & BMSR_LSTATUS)) {
+ int nego = miiphy_read_ret(ether_port_phy_addr[p->dev], MII_ADVERTISE) &
+ miiphy_read_ret(ether_port_phy_addr[p->dev], MII_LPA);
int want;
- if (nego & PHY_ANLPAR_TXFD) {
+ if (nego & LPA_100FULL) {
want = 0x3;
printf("MII: 100Base-TX, Full Duplex\n");
- } else if (nego & PHY_ANLPAR_TX) {
+ } else if (nego & LPA_100HALF) {
want = 0x1;
printf("MII: 100Base-TX, Half Duplex\n");
- } else if (nego & PHY_ANLPAR_10FD) {
+ } else if (nego & LPA_10FULL) {
want = 0x2;
printf("MII: 10Base-T, Full Duplex\n");
- } else if (nego & PHY_ANLPAR_10) {
+ } else if (nego & LPA_10HALF) {
want = 0x0;
printf("MII: 10Base-T, Half Duplex\n");
} else {