mx7dsabresd: Directly write to register LDOGCTL
Register LDOGCTL contains only bit 0 as a valid bit, so there is no need
to do a read-modify-write operation.
Simplify the code by writing directly to this register.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
diff --git a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
index c213861..5938c16 100644
--- a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
+++ b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c
@@ -193,9 +193,7 @@
reg, rev_id);
/* disable Low Power Mode during standby mode */
- pmic_reg_read(pfuze, PFUZE3000_LDOGCTL, ®);
- reg |= 0x1;
- pmic_reg_write(pfuze, PFUZE3000_LDOGCTL, reg);
+ pmic_reg_write(pfuze, PFUZE3000_LDOGCTL, 0x1);
/* SW1B step ramp up time from 2us to 4us/25mV */
reg = 0x40;