ppc4xx: Convert PPC4xx SDRAM defines from lower case to upper case
The latest PPC4xx register cleanup patch missed some SDRAM defines.
This patch now changes lower case UIC defines to upper case. Also
some names are changed to match the naming in the IBM/AMCC users
manuals (e.g. mem_mcopt1 -> SDRAM0_CFG).
Signed-off-by: Stefan Roese <sr@denx.de>
diff --git a/board/amcc/yosemite/yosemite.c b/board/amcc/yosemite/yosemite.c
index 731d441..1ec13eb 100644
--- a/board/amcc/yosemite/yosemite.c
+++ b/board/amcc/yosemite/yosemite.c
@@ -237,7 +237,7 @@
/* go through all possible SDRAM0_TR1[RDCT] values */
for (i=0; i<=0x1ff; i++) {
/* set the current value for TR1 */
- mtsdram(mem_tr1, (0x80800800 | i));
+ mtsdram(SDRAM0_TR1, (0x80800800 | i));
/* write values */
for (j=0; j<NUM_TRIES; j++) {
@@ -289,15 +289,15 @@
/*--------------------------------------------------------------------
* Setup some default
*------------------------------------------------------------------*/
- mtsdram(mem_uabba, 0x00000000); /* ubba=0 (default) */
- mtsdram(mem_slio, 0x00000000); /* rdre=0 wrre=0 rarw=0 */
- mtsdram(mem_devopt, 0x00000000); /* dll=0 ds=0 (normal) */
- mtsdram(mem_clktr, 0x40000000); /* ?? */
- mtsdram(mem_wddctr, 0x40000000); /* ?? */
+ mtsdram(SDRAM0_UABBA, 0x00000000); /* ubba=0 (default) */
+ mtsdram(SDRAM0_SLIO, 0x00000000); /* rdre=0 wrre=0 rarw=0 */
+ mtsdram(SDRAM0_DEVOPT, 0x00000000); /* dll=0 ds=0 (normal) */
+ mtsdram(SDRAM0_CLKTR, 0x40000000); /* ?? */
+ mtsdram(SDRAM0_WDDCTR, 0x40000000); /* ?? */
/*clear this first, if the DDR is enabled by a debugger
then you can not make changes. */
- mtsdram(mem_cfg0, 0x00000000); /* Disable EEC */
+ mtsdram(SDRAM0_CFG0, 0x00000000); /* Disable EEC */
/*--------------------------------------------------------------------
* Setup for board-specific specific mem
@@ -305,29 +305,29 @@
/*
* Following for CAS Latency = 2.5 @ 133 MHz PLB
*/
- mtsdram(mem_b0cr, 0x000a4001); /* SDBA=0x000 128MB, Mode 3, enabled */
- mtsdram(mem_b1cr, 0x080a4001); /* SDBA=0x080 128MB, Mode 3, enabled */
+ mtsdram(SDRAM0_B0CR, 0x000a4001); /* SDBA=0x000 128MB, Mode 3, enabled */
+ mtsdram(SDRAM0_B1CR, 0x080a4001); /* SDBA=0x080 128MB, Mode 3, enabled */
- mtsdram(mem_tr0, 0x410a4012); /* ?? */
- mtsdram(mem_rtr, 0x04080000); /* ?? */
- mtsdram(mem_cfg1, 0x00000000); /* Self-refresh exit, disable PM */
- mtsdram(mem_cfg0, 0x30000000); /* Disable EEC */
+ mtsdram(SDRAM0_TR0, 0x410a4012); /* ?? */
+ mtsdram(SDRAM0_RTR, 0x04080000); /* ?? */
+ mtsdram(SDRAM0_CFG1, 0x00000000); /* Self-refresh exit, disable PM */
+ mtsdram(SDRAM0_CFG0, 0x30000000); /* Disable EEC */
udelay(400); /* Delay 200 usecs (min) */
/*--------------------------------------------------------------------
* Enable the controller, then wait for DCEN to complete
*------------------------------------------------------------------*/
- mtsdram(mem_cfg0, 0x80000000); /* Enable */
+ mtsdram(SDRAM0_CFG0, 0x80000000); /* Enable */
for (;;) {
- mfsdram(mem_mcsts, reg);
+ mfsdram(SDRAM0_MCSTS, reg);
if (reg & 0x80000000)
break;
}
sdram_tr1_set(0x00000000, &tr1_bank1);
sdram_tr1_set(0x08000000, &tr1_bank2);
- mtsdram(mem_tr1, (((tr1_bank1+tr1_bank2)/2) | 0x80800800));
+ mtsdram(SDRAM0_TR1, (((tr1_bank1+tr1_bank2)/2) | 0x80800800));
return CONFIG_SYS_SDRAM_BANKS * (CONFIG_SYS_KBYTES_SDRAM * 1024); /* return bytes */
}