tqm5200: Correct comment and code in post_hotkeys_pressed.
This fixes the code and the comment according to the original intent of
doing an intensive memory test when PSC6_3 is pulled low on the STK52xx.
Notably PORT_CONFIG will be overridden with this correct code now,
so beware.
The original code only worked by coincidence depending on the PORT_CONFIG
setting from the header file. The new code was tested to ensure that the
(undocumented) memory test still works on the STK52x.
Signed-off-by: Detlev Zundel <dzu@denx.de>
CC: Martin Krause <Martin.Krause@tqs.de>
Minor white-space cleanup.
Signed-off-by: Wolfgang Denk <wd@denx.de>
diff --git a/board/tqc/tqm5200/tqm5200.c b/board/tqc/tqm5200/tqm5200.c
index faa2e02..5a091c4 100644
--- a/board/tqc/tqm5200/tqm5200.c
+++ b/board/tqc/tqm5200/tqm5200.c
@@ -358,11 +358,9 @@
gpio = (struct mpc5xxx_gpio*) MPC5XXX_GPIO;
/*
- * Configure PSC6_1 and PSC6_3 as GPIO. PSC6 then couldn't be used in
- * CODEC or UART mode. Consumer IrDA should still be possible.
+ * Configure PSC6_0 through PSC6_3 as GPIO.
*/
- gpio->port_config &= ~(0x07000000);
- gpio->port_config |= 0x03000000;
+ gpio->port_config &= ~(0x00700000);
/* Enable GPIO for GPIO_IRDA_1 (IR_USB_CLK pin) = PSC6_3 */
gpio->simple_gpioe |= 0x20000000;