Blackfin: use 8/16/32 bit transfer widths in dma_memcpy()
Rather than using 8bit transfers for everything, use 8/16/32 bit transfers
as usable with the source/destination addresses and the count size.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
diff --git a/lib_blackfin/string.c b/lib_blackfin/string.c
index e458718..12b6d24 100644
--- a/lib_blackfin/string.c
+++ b/lib_blackfin/string.c
@@ -136,6 +136,8 @@
*/
void dma_memcpy_nocache(void *dst, const void *src, size_t count)
{
+ uint16_t wdsize, mod;
+
/* Disable DMA in case it's still running (older u-boot's did not
* always turn them off). Do it before the if statement below so
* we can be cheap and not do a SSYNC() due to the forced abort.
@@ -151,24 +153,37 @@
(unsigned long)dst < L1_SRAM_SCRATCH_END))
hang();
+ if (((unsigned long)dst | (unsigned long)src | count) & 0x1) {
+ wdsize = WDSIZE_8;
+ mod = 1;
+ } else if (((unsigned long)dst | (unsigned long)src | count) & 0x2) {
+ wdsize = WDSIZE_16;
+ count >>= 1;
+ mod = 2;
+ } else {
+ wdsize = WDSIZE_32;
+ count >>= 2;
+ mod = 4;
+ }
+
/* Copy sram functions from sdram to sram */
/* Setup destination start address */
bfin_write_MDMA_D0_START_ADDR(dst);
/* Setup destination xcount */
bfin_write_MDMA_D0_X_COUNT(count);
/* Setup destination xmodify */
- bfin_write_MDMA_D0_X_MODIFY(1);
+ bfin_write_MDMA_D0_X_MODIFY(mod);
/* Setup Source start address */
bfin_write_MDMA_S0_START_ADDR(src);
/* Setup Source xcount */
bfin_write_MDMA_S0_X_COUNT(count);
/* Setup Source xmodify */
- bfin_write_MDMA_S0_X_MODIFY(1);
+ bfin_write_MDMA_S0_X_MODIFY(mod);
/* Enable source DMA */
- bfin_write_MDMA_S0_CONFIG(DMAEN);
- bfin_write_MDMA_D0_CONFIG(WNR | DMAEN | DI_EN);
+ bfin_write_MDMA_S0_CONFIG(wdsize | DMAEN);
+ bfin_write_MDMA_D0_CONFIG(wdsize | DMAEN | WNR | DI_EN);
SSYNC();
while (!(bfin_read_MDMA_D0_IRQ_STATUS() & DMA_DONE))