Change initdram() return type to phys_size_t
This patch changes the return type of initdram() from long int to phys_size_t.
This is required for a couple of reasons: long int limits the amount of dram
to 2GB, and u-boot in general is moving over to phys_size_t to represent the
size of physical memory. phys_size_t is defined as an unsigned long on almost
all current platforms.
This patch *only* changes the return type of the initdram function (in
include/common.h, as well as in each board's implementation of initdram). It
does not actually modify the code inside the function on any of the platforms;
platforms which wish to support more than 2GB of DRAM will need to modify
their initdram() function code.
Build tested with MAKEALL for ppc, arm, mips, mips-el. Booted on powerpc
MPC8641HPCN.
Signed-off-by: Becky Bruce <becky.bruce@freescale.com>
diff --git a/board/Marvell/db64360/sdram_init.c b/board/Marvell/db64360/sdram_init.c
index f04aaf9..ecadaf2 100644
--- a/board/Marvell/db64360/sdram_init.c
+++ b/board/Marvell/db64360/sdram_init.c
@@ -1728,7 +1728,7 @@
/* ppcboot interface function to SDRAM init - this is where all the
* controlling logic happens */
-long int initdram (int board_type)
+phys_size_t initdram (int board_type)
{
int s0 = 0, s1 = 0;
int checkbank[4] = {[0 ... 3] = 0 };
diff --git a/board/Marvell/db64460/sdram_init.c b/board/Marvell/db64460/sdram_init.c
index 1762202..f36f348 100644
--- a/board/Marvell/db64460/sdram_init.c
+++ b/board/Marvell/db64460/sdram_init.c
@@ -1737,7 +1737,7 @@
/* ppcboot interface function to SDRAM init - this is where all the
* controlling logic happens */
-long int initdram (int board_type)
+phys_size_t initdram (int board_type)
{
int s0 = 0, s1 = 0;
int checkbank[4] = {[0 ... 3] = 0 };