* Patch by David Brownell, 10 Mar 2005:
Restore copyright statements in OHCI drivers.
* Add support for TQM8540 board
diff --git a/cpu/arm920t/s3c24x0/usb_ohci.c b/cpu/arm920t/s3c24x0/usb_ohci.c
index 6f4a9f7..c5dac27 100644
--- a/cpu/arm920t/s3c24x0/usb_ohci.c
+++ b/cpu/arm920t/s3c24x0/usb_ohci.c
@@ -4,6 +4,10 @@
* (C) Copyright 2003
* Gary Jennejohn, DENX Software Engineering <gj@denx.de>
*
+ * Note: Much of this code has been derived from Linux 2.4
+ * (C) Copyright 1999 Roman Weissgaerber <weissg@vienna.at>
+ * (C) Copyright 2000-2002 David Brownell
+ *
* See file CREDITS for list of people who contributed to this
* project.
*
@@ -22,8 +26,6 @@
* Foundation, Inc., 59 Temple Place, Suite 330, Boston,
* MA 02111-1307 USA
*
- * Note: Part of this code has been derived from linux
- *
*/
/*
* IMPORTANT NOTES
diff --git a/cpu/mpc5xxx/usb_ohci.c b/cpu/mpc5xxx/usb_ohci.c
index 55f6d35..8806826 100644
--- a/cpu/mpc5xxx/usb_ohci.c
+++ b/cpu/mpc5xxx/usb_ohci.c
@@ -7,6 +7,10 @@
* (C) Copyright 2004
* Pierre Aubert, Staubli Faverges <p.aubert@staubli.com>
*
+ * Note: Much of this code has been derived from Linux 2.4
+ * (C) Copyright 1999 Roman Weissgaerber <weissg@vienna.at>
+ * (C) Copyright 2000-2002 David Brownell
+ *
* See file CREDITS for list of people who contributed to this
* project.
*
@@ -25,8 +29,6 @@
* Foundation, Inc., 59 Temple Place, Suite 330, Boston,
* MA 02111-1307 USA
*
- * Note: Part of this code has been derived from linux
- *
*/
/*
* IMPORTANT NOTES
diff --git a/cpu/mpc85xx/config.mk b/cpu/mpc85xx/config.mk
index 4b11fc7..a51527a 100644
--- a/cpu/mpc85xx/config.mk
+++ b/cpu/mpc85xx/config.mk
@@ -23,4 +23,4 @@
PLATFORM_RELFLAGS += -fPIC -ffixed-r14 -meabi
-PLATFORM_CPPFLAGS += -DCONFIG_MPC85xx -DCONFIG_E500 -ffixed-r2 -ffixed-r29 -Wa,-me500 -msoft-float
+PLATFORM_CPPFLAGS += -DCONFIG_MPC85xx -DCONFIG_E500 -ffixed-r2 -ffixed-r29 -Wa,-me500 -msoft-float -O2
diff --git a/cpu/mpc85xx/tsec.c b/cpu/mpc85xx/tsec.c
index 3255db8..de056d9 100644
--- a/cpu/mpc85xx/tsec.c
+++ b/cpu/mpc85xx/tsec.c
@@ -46,15 +46,15 @@
* knowledge that all current implementations have 2 TSEC
* devices, and one FEC. The information needed is:
* phyaddr - The address of the PHY which is attached to
- * the given device.
+ * the given device.
*
* gigabit - This variable indicates whether the device
- * supports gigabit speed ethernet
+ * supports gigabit speed ethernet
*
* phyregidx - This variable specifies which ethernet device
- * controls the MII Management registers which are connected
- * to the PHY. For 8540/8560, only TSEC1 (index 0) has
- * access to the PHYs, so all of the entries have "0".
+ * controls the MII Management registers which are connected
+ * to the PHY. For 8540/8560, only TSEC1 (index 0) has
+ * access to the PHYs, so all of the entries have "0".
*
* The values specified in the table are taken from the board's
* config file in include/configs/. When implementing a new
@@ -71,12 +71,18 @@
static struct tsec_info_struct tsec_info[] = {
#ifdef CONFIG_MPC85XX_TSEC1
{TSEC1_PHY_ADDR, 1, TSEC1_PHYIDX},
+#else
+ { 0, 0, 0},
#endif
#ifdef CONFIG_MPC85XX_TSEC2
{TSEC2_PHY_ADDR, 1, TSEC2_PHYIDX},
+#else
+ { 0, 0, 0},
#endif
#ifdef CONFIG_MPC85XX_FEC
{FEC_PHY_ADDR, 0, FEC_PHYIDX},
+#else
+ { 0, 0, 0},
#endif
};
@@ -160,7 +166,7 @@
/* Initializes data structures and registers for the controller,
- * and brings the interface up. Returns the link status, meaning
+ * and brings the interface up. Returns the link status, meaning
* that it returns success if the link is up, failure otherwise.
* This allows u-boot to find the first active controller. */
int tsec_init(struct eth_device* dev, bd_t * bd)
@@ -228,7 +234,7 @@
/* Reads register regnum on the device's PHY through the
- * registers specified in priv. It lowers and raises the read
+ * registers specified in priv. It lowers and raises the read
* command, and waits for the data to become valid (miimind
* notvalid bit cleared), and the bus to cease activity (miimind
* busy bit cleared), and then returns the value
@@ -543,9 +549,9 @@
regs->dmactrl &= ~(DMACTRL_GRS | DMACTRL_GTS);
}
-/* This returns the status bits of the device. The return value
+/* This returns the status bits of the device. The return value
* is never checked, and this is what the 8260 driver did, so we
- * do the same. Presumably, this would be zero if there were no
+ * do the same. Presumably, this would be zero if there were no
* errors */
static int tsec_send(struct eth_device* dev, volatile void *packet, int length)
{
@@ -669,6 +675,38 @@
},
};
+struct phy_info phy_info_M88E1111S = {
+ 0x01410cc,
+ "Marvell 88E1111S",
+ 4,
+ (struct phy_cmd[]) { /* config */
+ /* Reset and configure the PHY */
+ {MIIM_CONTROL, MIIM_CONTROL_RESET, NULL},
+ {0x1d, 0x1f, NULL},
+ {0x1e, 0x200c, NULL},
+ {0x1d, 0x5, NULL},
+ {0x1e, 0x0, NULL},
+ {0x1e, 0x100, NULL},
+ {MIIM_GBIT_CONTROL, MIIM_GBIT_CONTROL_INIT, NULL},
+ {MIIM_ANAR, MIIM_ANAR_INIT, NULL},
+ {MIIM_CONTROL, MIIM_CONTROL_RESET, NULL},
+ {MIIM_CONTROL, MIIM_CONTROL_INIT, &mii_cr_init},
+ {miim_end,}
+ },
+ (struct phy_cmd[]) { /* startup */
+ /* Status is read once to clear old link state */
+ {MIIM_STATUS, miim_read, NULL},
+ /* Auto-negotiate */
+ {MIIM_STATUS, miim_read, &mii_parse_sr},
+ /* Read the status */
+ {MIIM_88E1011_PHY_STATUS, miim_read, &mii_parse_88E1011_psr},
+ {miim_end,}
+ },
+ (struct phy_cmd[]) { /* shutdown */
+ {miim_end,}
+ },
+};
+
struct phy_info phy_info_cis8204 = {
0x3f11,
"Cicada Cis8204",
@@ -755,19 +793,41 @@
},
};
+static struct phy_info phy_info_lxt971 = {
+ 0x0001378e,
+ "LXT971",
+ 4,
+ (struct phy_cmd []) { /* config */
+ { MIIM_CONTROL, MIIM_CONTROL_INIT, mii_cr_init }, /* autonegotiate */
+ { miim_end, }
+ },
+ (struct phy_cmd []) { /* startup - enable interrupts */
+ /* { 0x12, 0x00f2, NULL }, */
+ { 0x14, 0xd422, NULL }, /* LED config */
+ { MIIM_STATUS, miim_read, NULL },
+ { MIIM_STATUS, miim_read, mii_parse_sr },
+ { miim_end, }
+ },
+ (struct phy_cmd []) { /* shutdown - disable interrupts */
+ { miim_end, }
+ },
+};
+
struct phy_info *phy_info[] = {
#if 0
&phy_info_cis8201,
#endif
&phy_info_cis8204,
&phy_info_M88E1011S,
+ &phy_info_M88E1111S,
&phy_info_dm9161,
+ &phy_info_lxt971,
NULL
};
/* Grab the identifier of the device's PHY, and search through
- * all of the known PHYs to see if one matches. If so, return
+ * all of the known PHYs to see if one matches. If so, return
* it, if not, return NULL */
struct phy_info * get_phy_info(struct eth_device *dev)
{