microblaze: spl: configure SYS_MALLOC_F_LEN independently for SPL and full U-Boot
Some platforms have very limited SRAM to run SPL code, so there may
not be the same amount space for a malloc pool before relocation in
the SPL stage as the normal U-Boot stage.
Make SPL and (the full) U-Boot stage use independent SYS_MALLOC_F_LEN,
so the size of pre-relocation malloc pool can be configured memory
space independently.
Signed-off-by: Andy Yan <andy.yan@rock-chips.com>
Acked-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>
Reviewed-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>
[fixed up commit-message:]
Signed-off-by: Philipp Tomsich <philipp.tomsich@theobroma-systems.com>
diff --git a/arch/microblaze/cpu/start.S b/arch/microblaze/cpu/start.S
index 79dc0cf..baf4f51 100644
--- a/arch/microblaze/cpu/start.S
+++ b/arch/microblaze/cpu/start.S
@@ -31,8 +31,8 @@
mts rshr, r1
addi r1, r1, -4 /* Decrement SP to top of memory */
#else
-#if defined(CONFIG_SYS_MALLOC_F_LEN)
- addi r1, r0, CONFIG_SYS_INIT_SP_OFFSET - CONFIG_SYS_MALLOC_F_LEN
+#if CONFIG_VAL(SYS_MALLOC_F_LEN)
+ addi r1, r0, CONFIG_SYS_INIT_SP_OFFSET - CONFIG_VAL(SYS_MALLOC_F_LEN)
#else
addi r1, r0, CONFIG_SYS_INIT_SP_OFFSET
#endif
@@ -162,14 +162,14 @@
#ifndef CONFIG_SPL_BUILD
or r5, r0, r0 /* flags - empty */
addi r31, r0, _gd
-#if defined(CONFIG_SYS_MALLOC_F_LEN)
+#if CONFIG_VAL(SYS_MALLOC_F_LEN)
addi r6, r0, CONFIG_SYS_INIT_SP_OFFSET
swi r6, r31, GD_MALLOC_BASE
#endif
brai board_init_f
#else
addi r31, r0, _gd
-#if defined(CONFIG_SYS_MALLOC_F_LEN)
+#if CONFIG_VAL(SYS_MALLOC_F_LEN)
addi r6, r0, CONFIG_SPL_STACK_ADDR
swi r6, r31, GD_MALLOC_BASE
#endif