powerpc/mpc85xx:Put errata number for T104x NAND boot issue
When device is configured to load RCW from NAND flash IFC_A[16:31] are driven
low after RCW loading. Hence Devices connected on IFC_CS[1:7] and using
IFC_A[16:31] lines are not accessible.
Workaround is already in-place.
Put the errata number to adhere errata handling framework.
Signed-off-by: Prabhakar Kushwaha <prabhakar@freescale.com>
Reviewed-by: York Sun <yorksun@freescale.com>
diff --git a/board/freescale/t104xrdb/spl.c b/board/freescale/t104xrdb/spl.c
index 3822a37..75d9d9c 100644
--- a/board/freescale/t104xrdb/spl.c
+++ b/board/freescale/t104xrdb/spl.c
@@ -34,12 +34,12 @@
void board_init_f(ulong bootflag)
{
u32 plat_ratio, sys_clk, uart_clk;
-#ifdef CONFIG_SPL_NAND_BOOT
+#if defined(CONFIG_SPL_NAND_BOOT) && defined(CONFIG_A008044_WORKAROUND)
u32 porsr1, pinctl;
#endif
ccsr_gur_t *gur = (void *)CONFIG_SYS_MPC85xx_GUTS_ADDR;
-#ifdef CONFIG_SPL_NAND_BOOT
+#if defined(CONFIG_SPL_NAND_BOOT) && defined(CONFIG_A008044_WORKAROUND)
/*
* There is T1040 SoC issue where NOR, FPGA are inaccessible during
* NAND boot because IFC signals > IFC_AD7 are not enabled.