env: Finish migration of common ENV options
- In ARMv8 NXP Layerscape platforms we also need to make use of
CONFIG_SYS_RELOC_GD_ENV_ADDR now, do so.
- On ENV_IS_IN_REMOTE, CONFIG_ENV_OFFSET is never used, drop the define
to 0.
- Add Kconfig entry for ENV_ADDR.
- Make ENV_ADDR / ENV_OFFSET depend on the env locations that use it.
- Add ENV_xxx_REDUND options that depend on their primary option and
SYS_REDUNDAND_ENVIRONMENT
- On a number of PowerPC platforms, use SPL_ENV_ADDR not CONFIG_ENV_ADDR
for the pre-main-U-Boot environment location.
- On ENV_IS_IN_SPI_FLASH, check not for CONFIG_ENV_ADDR being set but
rather it being non-zero, as it will now be zero by default.
- Rework the env_offset absolute in env/embedded.o to not use
CONFIG_ENV_OFFSET as it was the only use of ENV_OFFSET within
ENV_IS_IN_FLASH.
- Migrate all platforms.
Cc: Wolfgang Denk <wd@denx.de>
Cc: Joe Hershberger <joe.hershberger@ni.com>
Cc: Patrick Delaunay <patrick.delaunay@st.com>
Cc: uboot-stm32@st-md-mailman.stormreply.com
Signed-off-by: Tom Rini <trini@konsulko.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
Reviewed-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
diff --git a/board/freescale/t208xqds/spl.c b/board/freescale/t208xqds/spl.c
index 9695dfc..f0499ad 100644
--- a/board/freescale/t208xqds/spl.c
+++ b/board/freescale/t208xqds/spl.c
@@ -111,19 +111,19 @@
#ifdef CONFIG_SPL_NAND_BOOT
nand_spl_load_image(CONFIG_ENV_OFFSET, CONFIG_ENV_SIZE,
- (uchar *)CONFIG_ENV_ADDR);
+ (uchar *)SPL_ENV_ADDR);
#endif
#ifdef CONFIG_SPL_MMC_BOOT
mmc_initialize(bd);
mmc_spl_load_image(CONFIG_ENV_OFFSET, CONFIG_ENV_SIZE,
- (uchar *)CONFIG_ENV_ADDR);
+ (uchar *)SPL_ENV_ADDR);
#endif
#ifdef CONFIG_SPL_SPI_BOOT
fsl_spi_spl_load_image(CONFIG_ENV_OFFSET, CONFIG_ENV_SIZE,
- (uchar *)CONFIG_ENV_ADDR);
+ (uchar *)SPL_ENV_ADDR);
#endif
- gd->env_addr = (ulong)(CONFIG_ENV_ADDR);
+ gd->env_addr = (ulong)(SPL_ENV_ADDR);
gd->env_valid = ENV_VALID;
i2c_init_all();