warp7: hab: Set environment variable indicating HAB enable
This patch adds an environment variable called "hab_enabled" which gets set
to a boolean status indicating whether HAB is enabled or not.
Subsequent patches can use this environment variable to determine if its
necessary to run a given binary through the hab_auth_img console command.
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Tested-by: Breno Lima <breno.lima@nxp.com>
Reviewed-by: Fabio Estevam <fabio.estevam@nxp.com>
diff --git a/board/warp7/warp7.c b/board/warp7/warp7.c
index 327f656..0d3d324 100644
--- a/board/warp7/warp7.c
+++ b/board/warp7/warp7.c
@@ -10,6 +10,7 @@
#include <asm/arch/mx7-pins.h>
#include <asm/arch/sys_proto.h>
#include <asm/gpio.h>
+#include <asm/mach-imx/hab.h>
#include <asm/mach-imx/iomux-v3.h>
#include <asm/mach-imx/mxc_i2c.h>
#include <asm/io.h>
@@ -203,6 +204,13 @@
*/
clrsetbits_le16(&wdog->wcr, 0, 0x10);
+#ifdef CONFIG_SECURE_BOOT
+ /* Determine HAB state */
+ env_set_ulong(HAB_ENABLED_ENVNAME, imx_hab_is_enabled());
+#else
+ env_set_ulong(HAB_ENABLED_ENVNAME, 0);
+#endif
+
#ifdef CONFIG_SERIAL_TAG
/* Set serial# standard environment variable based on OTP settings */
get_board_serial(&serialnr);