mtd: move NAND files into a raw/ subdirectory
NAND flavors, like serial and parallel, have a lot in common and would
benefit to share code. Let's move raw (parallel) NAND specific code in a
raw/ subdirectory, to ease the addition of a core file in nand/ and the
introduction of a spi/ subdirectory specific to SPI NANDs.
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
diff --git a/common/spl/Kconfig b/common/spl/Kconfig
index 280496f..18dbc23 100644
--- a/common/spl/Kconfig
+++ b/common/spl/Kconfig
@@ -487,7 +487,7 @@
help
Enable support for NAND (Negative AND) flash in SPL. NAND flash
can be used to allow SPL to load U-Boot from supported devices.
- This enables the drivers in drivers/mtd/nand as part of an SPL
+ This enables the drivers in drivers/mtd/nand/raw as part of an SPL
build.
config SPL_NET_SUPPORT
diff --git a/common/spl/spl_spi.c b/common/spl/spl_spi.c
index ba60a3a..0016d49 100644
--- a/common/spl/spl_spi.c
+++ b/common/spl/spl_spi.c
@@ -2,7 +2,7 @@
/*
* Copyright (C) 2011 OMICRON electronics GmbH
*
- * based on drivers/mtd/nand/nand_spl_load.c
+ * based on drivers/mtd/nand/raw/nand_spl_load.c
*
* Copyright (C) 2011
* Heiko Schocher, DENX Software Engineering, hs@denx.de.